Advertisement
Quick Links
Mounting Your Biometric 2500 or
Proximity 2000 Time Clock
Make Sure You Have These Items
•
This instruction sheet
•
Paychex time clock
•
Mounting plate (1)
•
Screws and drywall screw anchors
Mounting Your Biometric 2500 or Proximity 2000 Time Clock Paychex Time and Labor Online
© 2012 Paychex, Inc. All rights reserved. TLO-4207-120803
1
Advertisement
Related Manuals for PAYCHEX Biometric 2500
Summary of Contents for PAYCHEX Biometric 2500
- Page 1 Proximity 2000 Time Clock Make Sure You Have These Items • This instruction sheet • Paychex time clock • Mounting plate (1) • Screws and drywall screw anchors Mounting Your Biometric 2500 or Proximity 2000 Time Clock Paychex Time and Labor Online © 2012 Paychex, Inc. All rights reserved. TLO-4207-120803...
- Page 2 Do not place the time clock outdoors without adequate protection from weather or vandalism. • Do not place the time clock under strong light. • Use a regulated 12-V dc3A power source for the time clock. • The operating temperature for the clock is 0º to 45ºC (32º to 113ºF). • The operating humidity for the clock is 20 to 80%. Mounting Tools Needed • Flat head screwdriver • Hand drill Use the drill to make small set holes for the screw anchors. Mounting Your Biometric 2500 or Proximity 2000 Time Clock Paychex Time and Labor Online © 2012 Paychex, Inc. All rights reserved. TLO-4207-120803...
- Page 3 Replace the mounting plate over the four holes and, using the four screws the hole in the plate for the provided, attach the back plate of the clock on to the wall. wires. Connect the power and network cables to the time clock. Using the tabs on the mounting plate and clock itself, angle the clock to attach it to the mounting plate and the wall. (1) Refasten the black screw in the bottom of the time clock and tighten. (2) Mounting Your Biometric 2500 or Proximity 2000 Time Clock Paychex Time and Labor Online © 2012 Paychex, Inc. All rights reserved. TLO-4207-120803...
- Page 4 Removing the Time Clock from the Mounting Plate To remove the time clock from the mounting plate, follow these steps: Using a flat head screwdriver, remove the black screw in the bottom of the time clock. Angle the clock and gently remove it from the mounting plate. If you have additional questions about mounting your Paychex Time Clock, contact the Time and Attendance Center at the number listed on the Training page. Mounting Your Biometric 2500 or Proximity 2000 Time Clock Paychex Time and Labor Online © 2012 Paychex, Inc. All rights reserved. TLO-4207-120803...