QMAXZ Lighting QM Series User Manual

Hide thumbs

Table Of Contents

Table of Contents

Quick Links

USER MANUAL ENGLISH Version 3.06

M-series

QMAXZ Lighting

2009,

www.qmaxz.com

Table of Contents

Need help?

Do you have a question about the QM Series and is the answer not in the manual?

Questions and answers

Summary of Contents for QMAXZ Lighting QM Series

Page 3: Table Of Contents
10.2 Photometric data Page 32 10.3 Dimensional drawings Page 33 11. DMX Protocol Page 34 11.1 QM(E)575S/QM(E)700S Page 34 11.2 QM(E)575W/QM(E)700W Page 37 12. Troubleshooting Page 39 13. Info Page 40 QM series manual v3.06 - 2 - ©QMAXZ 2009...
Page 4: Introduction
For the latest updates of product documentation, please visit the user support area of the QMAXZ website at www.qmaxz.com NOTE: Information and Specifications in this document are subject to change without notice. QMAXZ Lighting assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual. 2. UNPACKING...
Page 5: Rigging The Fixture
10 times the weight of the fixture. To un-mount the brackets turn the twist lock by 90 degrees counter clockwise and release the brackets from the fixture base. QM series manual v3.06 - 4 - ©QMAXZ 2009...
Page 6: Lamp Replacement
QMAXZ fixtures are tested with PHILIPS bulbs. QMAXZ also advises to use the same bulbs for replacement. QMAXZ is not responsible for any damage to the fixture when using other bulbs! QM series manual v3.06 - 5 - ©QMAXZ 2009...
Page 7: Lamp Installation
3. Turn the screws one by one clockwise and/or counter clockwise until the hotspot is in the centre of the beam. If you cannot detect the hotspot, adjust the lamp until the output is evenly spread over the beam and the output is the brightest. QM series manual v3.06 - 6 - ©QMAXZ 2009...
Page 8: Power And Signal Connection
4. Connect the mains power again and turn on the fixture to check proper operation. There are also two fuses on the main PCB board inside the fixture, for how to replace this please contact your dealer. QM series manual v3.06 - 7 - ©QMAXZ 2009...
Page 9: Signal Connection
Do not overload the link. A maximum of 10 devices may be connected on a serial link. Insert a male 120Ω XLR termination plug, in the last fixture. This to avoid signal reflection and interference. DMX Terminator DMX connection panel QM series manual v3.06 - 8 - ©QMAXZ 2009...
Page 10: Fixture Start Up
When no button on the control panel is touched for more then 15 seconds the display will turn off and the menu will go back to the DMX start address, to turn it on simply press a button and repeat the above steps to enter the menu. QM series manual v3.06 - 9 - ©QMAXZ 2009...
Page 11: Function Menu Qm(E)575S/Qm(E)700S
7.2 Function Menu QM(E)575S/QM(E)700S. QM series manual v3.06 - 10 - ©QMAXZ 2009...
Page 17 FAN SPEED HIGH [DOWN] > to next menu DOWN MENU_O3 FAN SPEED FAN SPEED TEST XX TEST [MENU] > to enter test mode [UP/DOWN] > increase/ decrease test speed 01 - 20 QM series manual v3.06 - 16 - ©QMAXZ 2009...
Page 18 QM(E)575S / QM(E)700S DOWN MENU 2 DMX MODE ## RUN MODE ONLY FOR SERVICE FAN MODE CENTER SERVICE DOWN Back to top QM series manual v3.06 - 17 - ©QMAXZ 2009...
Page 19: Function Menu Qm(E)575W/Qm(E)700W
TILT MOVE [MENU] > save new setting SPEED and return to menu 2 [ESC] > no change in setting and return to menu 2 MENU_C2 DOWN [UP/DOWN] > swop selection REVERSE QM series manual v3.06 - 18 - ©QMAXZ 2009...
Page 27: Menu Functions
RESET MENU Perform a complete or partitional reset, set to factory default, set DMX reset mode, use [UP] or [DOWN] buttons to select, press [MENU] to perform or save. TEMP MODE QM series manual v3.06 - 26 - ©QMAXZ 2009...
Page 28 Speed Test. When select FAN Speed Test you can run through all 20 steps of the fan speed control. Push [MENU] to enter or [ESC] to return to menu. SERVICE This menu is for service centre only and is password protected. Please contact your local dealer for details. QM series manual v3.06 - 27 - ©QMAXZ 2009...
Page 29: Control Dmx Channels
√ √ Magenta √ √ √ √ Yellow √ √ √ √ √ √ √ √ CMY speed √ √ √ √ Zoom √ √ √ √ √ √ √ √ QM series manual v3.06 - 28 - ©QMAXZ 2009...
Page 30: Gobo And Gobo Size
QGM10 QGM11 QGM12 QGM13 8.2 Rotating / Glass Gobos overall size 28mm, image size 21,5mm Standard factory installed: QGG1 QGG2 QGG3 QGG4 QGG5 QGG6 Optional gobo’s: QGG7 QGG8 QGG9 QGG10 QGG11 QM series manual v3.06 - 29 - ©QMAXZ 2009...
Page 31: Gobo Positions
6. Put in a new gobo by sliding it in the pocket on the wheel, and secure it with a drop of glue. 7. Attach the safety cable of the cover again, and put the cover back on, tighten the 4 screws. QM series manual v3.06 - 30 -...
Page 32: Maintenance
The QMAXZ fixture does not require lubrication under normal circumstances. The slides for the zoom and focus lens cars are lubricated with a long-lasting Teflon-based grease that can be reapplied by you’re dealer. Check main power plug regularly, for connection and mechanical liability. QM series manual v3.06 - 31 - ©QMAXZ 2009...
Page 33: Qm-Series Technical Data
3° 3° 3° Dimensions Fixture 699x504x365 699x504x365 699x504x365 699x504x365 Dimension Carton 775x520x520 775x520x520 775x520x520 775x520x520 Net. Weight 40(34)Kg 40(34)Kg 40Kg 40Kg Gross Weight 43(37)Kg 43(37)Kg 43Kg 43Kg 10.2 Photometric Data QM(E)575S/QM(E)575W QM series manual v3.06 - 32 - ©QMAXZ 2009...
Page 35: Dmx Protocol
Random opening pulse, slow 220-229 Random closing pulse, fast 230-239 Random closing pulse, medium 240-249 Random closing pulse, slow 250-255 Shutter open 8/16BIT 0-255 Pan 540° (128=neutral) 8/16BIT 0-255 Tilt 250° (128=neutral) TILT QM series manual v3.06 - 34 - ©QMAXZ 2009...
Page 36 (ROTATING) 175-189 Gobo 4, shake slow -> fast 190-204 Gobo 3, shake slow -> fast 205-219 Gobo 2, shake slow -> fast 220-234 Gobo 1, shake slow -> fast 235-255 open QM series manual v3.06 - 35 - ©QMAXZ 2009...
Page 37 All function change blackout 240-255 No blackout Pan/tilt speed fast PAN/TILT 8/16BIT SPEED 10-255 Pan/tilt speed, fast -> slow 16BIT 0-255 Pan fine PAN FINE 16BIT 0-255 Tilt fine TILT FINE QM series manual v3.06 - 36 - ©QMAXZ 2009...
Page 38: Qm(E)575W/Qm(E)700W
Random opening pulse, slow 220-229 Random closing pulse, fast 230-239 Random closing pulse, medium 240-249 Random closing pulse, slow 250-255 Shutter open 8/16BIT 0-255 Pan 540° (128=neutral) 8/16BIT 0-255 Tilt 250° (128=neutral) TILT QM series manual v3.06 - 37 - ©QMAXZ 2009...
Page 39 Pan/tilt movement, blackout 210-239 All functions, blackout 240-255 No blackout Fastest PAN/TILT 16BIT SPEED 10-225 Pan/tilt speed, fast -> slow 16BIT 0-255 Pan fine PAN FINE 16BIT 0-255 Tilt fine TILT FINE QM series manual v3.06 - 38 - ©QMAXZ 2009...
Page 40: Troubleshooting
Disconnect the mains power supply and replace the Lamp has reached the end of his lamp (see chapter 5). lifetime cycle. QM series manual v3.06 - 39 - ©QMAXZ 2009...
Page 41: Info
If there is any doubt of safe operation during the products lifetime please contact your dealer or QMAXZ lighting at all times to check whether it is safe to use the product before operating it. QMAXZ lighting Mr.

This manual is also suitable for:

Qm575s Qm575w Qme575s Qme575w Qm700s Qm700w