EARTHBOARD EBII Quick Start Manual

Congratulations on your EARTHBOARD EBII with high draw upgrade! Your EBII is capable of using the rechargeable
Battery provided for higher draw pedals. You may also use the Power Station AC adapter instead of the battery.
To understand how pedals attach to Gravity Boots along with Gravity Boot Tethers, take a look at the
quick start guide was written referencing our other model, but the use of the Gravity Boots, Gravity Boot Tethers remains the
same.
Dual
Battery
Inputs
To pedal
or from
AC adapter
Additional Notes:
• For the high draw upgrade use both battery tethers provided, with one plugged into each USB output on the battery. Then
plug them into the board. If the board does not power immediately, press the reset button on the battery, top left side. The
blue LED lights up on the board when powered.
• Important! The EBII can be powered by battery OR AC Adapter power. Not both at the same time.
• When changing pedals, we recommend you turn power off to the EARTHBOARD.
• Like any electronic equipment, the EBII should be handled properly. Your EBII has electrical short protection in the
battery & the Power Station AC adapter. Avoid exposure to liquids.
Quick Start Guide.
CONTINUED ON BACK OF PAGE.......
The
To pedal
or from
AC adapter