Summary of Contents for AmbuTrak 1001
- Page 1 TO HELP WITH INSTALLATION OF YOUR AMBUTRAK – PLEASE SEARCH “AMBUTRAK LLC” on YouTube or Scan the QR CODE BELOW WITH YOUR SMARTPHONE’S CAMERA FOR EASY INSTALL VIDEO!! THANK YOU ☺ Scan Here!
- Page 2 1. Attach computer to crossbar of walker using 2 zip ties. Tie securely. Cut excess zip tie. (Standard 2-wheel walker on left, rollator setup on right) 2. Next, use two zip ties to secure sensor close to wheel spokes. Position sensor very close to wheel spokes, without causing sensor to rub.
- Page 3 (diameter)x3.14. So in this case, (191) x 3.14 = 600. Put this number into the AmbuTrak by toggling the right and left buttons. The left chooses the digit and the right button moves the digit place holder on the screen. Once you have the number set to where you want, just wait and allow the screen to flash back to the home screen.
- Page 4 1. Make sure sensor is close enough to flat surface of grey clip to “sense” wheel moving 2. Make sure AmbuTrak is set to “398”. If this number changes, press and hold both buttons and adjust number back to “398” using R and L buttons to toggle each number.
Need help?
Do you have a question about the 1001 and is the answer not in the manual?
Questions and answers