StayD MG5000 Installer Setup Manual

Step A: Define the zones

Set up your zones as you would normally and define which zones are disabled during Stay or Sleep arming.
See the Zone Definitions table in the panel's respective Programming Guide.

Step B: Assign entry point zones and paths to keypads

1 Go to each keypad that requires entry point zone assignment. When you assign a path to a keypad, StayD is
automatically enabled.
2 [ ] + [
ENTER INSTALLER CODE
3 Press and hold the [
4 Enter the desired zone number(s):
MG32LRF, MG32LCD, MG32I, MG32LED = 2-digit entry - 01 to 32
MG10LEDV/H, K636 = 1-digit entry - 1 to 0(10)
The first zone you program will be the designated entry point and will flash. Up to three more path zones can
be added; these zones will light up and stay lit.
5 Press [ ] to save and exit.
ENTER

Step C: Activate StayD mode

1 Go to any keypad.
2 [ ] + [
STAY USER CODE
3 The StayD LED will light up to confirm StayD activation.
Congratulations, your system is now StayD enabled and ready.
StayD Installer Setup Guide
*For new unprogrammed panels or reset panels*
StayD Enabled Panels
] (default: 0000 / 000000).
] key for three seconds.
OFF
] + (If partitioned, press 1 and/or 2) + [
Control Panel
MG5000 / MG5050
SP5500 / SP6000 / SP7000
Esprit E55
STAY
].