Summary of Contents for Bakko Industries 303 JUG
- Page 1 303 JUG Horse Stall Waterers Operation Manual 303 Corner Mount 303 Flat Back Bakko Industries, Inc. Glenwood, MN 56334...
- Page 2 Information in this manual. Information in this document is subject to change without notice and does not represent a commitment on the part of Bakko Industries, Inc. PRODUCT WARNINGS-ELECTRICAL 1. To prevent electrical shock, disconnect the main power before servicing electrical components.
- Page 3 The size waterline of choice going from the buried horizontal underground waterline up through the Riser Tube into the 303 JUG is 1/2” inch in diameter. This is a commonly used size, and will allow enough room for the waterline to get from the riser tube up into the Service Tunnel of the JUG.
-
Page 4: Final Installation Steps
Insert the 1/2 inch X 1/2 inch Hose Barb/Elbow into the incoming 1/2 inch waterline and secure with a hose clamp. (If you are not using a standard 1/2 inch waterline to supply the 303 Jug, you will need to provide your own Barb/Elbow fitting components.) Using thread sealant, attach the enclosed Brass Nipple to the incoming Barb/Elbow. -
Page 5: Trouble Shooting Tip
11. At this time check all water fittings , and connections for leaks. By following these instructions you should realize the trouble free performance of the 303 JUG that customers have come to expect over the years. - Page 6 Mounted in Air Tunnel of JUG String Heater 303 Riser Tube Slide string heater down center of riser tube When placing a 303 JUG on a 303 Riser String Heaters for 303 Riser Tubes Tube, it is recommended that a string Part # Length...
- Page 7 A vacuum as small as 2 gallons will work well. One or two sucks with the vacuum will do an excellent job of cleaning the feed trap. Remember that draining the 2 gallon reservoir of the 303 JUG is as easy as removing the front mounted external drain plug. 303 Feed Trap Top View of 303 Corner Mount 19 1/2”...
- Page 8 Typical 303 Corner Mount Installation Typical 303 Flat Back Installation 303 JUG Bite Guard External Drain Plug Riser Tube 303 Corner Mount Specifications 303 Flat Back Specifications Sides Sides Top back corner to front curve = 14 inches Top back center to front curve = 16 inches...