QUATROS QS19134 Owner's Manual

OWNER'SMANUAL
HYDRAULIC TROLLEY JACK LOW PROFILE, DUAL PUMP 3T
QS19134
DESCRIPTION
Hydraulic Trolley Jack Low Profile Dual Pump 3T QS19134: Capacity: 3T | Min. height: 75mm | Max. height: 500mm | Weight: 33kg
SAFETY INSTRUCTIONS
WARNING
- This jack is a lifting device, designed ONLY for lifting part of the total vehicle (i.e one wheel). Do not move or dolly the
vehicle while itis on the jack. Never use lift device to raise any others load.
- Position this jack to ONLY lift on the areas of the vehicle as specified by the vehicle manufacturer.
- After lifting the vehicle, ALWAYS support the load with appropriately rated vehicle support stands BEFORE working on the
vehicle.
- Do not overload this jack beyond its rated capacity. Overloading can cause damage to or failure of the jack.
- This jack is designed ONLY for use on hard level surfaces capable of sustaining the load. Use on other than hard level
surfaces can result in jack instability and possible loss of load.
- Center load on jack saddle BEFORE lifting vehicle. Off-center loads and loads lifted when the jack is not level can cause loss
of load or damage to the jack.
- Study, understand and follow all instructions in this manual BEFORE operating the jack.
- Failure to heed this warning may result in loss of load, damage to the jack and/or jack failure resulting in personal injury or
property damage.
OPERATION
WARNING! Ensure that you read, understand and apply the safety instructions.
ASSEMBLING HANDLE
Insert handle piece (part no. 19) into middle handle piece (part no. 18) making sure holes
line up for retaining clips. With the jack sitting on its wheels on a flat surface, slide
assembled handle into handle base (part no. 20), rotate until the square-shaped hole slips
over shaft in handle base. Loosen ½ turn handle should rotate easily.
At the rear of jack a large metal clip holds handle base flat against the jack. While keeping
handle pushed down in compressed position, carefully remove clip by pulling out. Release
pressure on handle base and discard.
PREPARING WORK AREA
Before using jack to lift vehicle it is important to prepare work area properly. Follow this procedure each time the jack is used to
help prevent property damage and or serious injury.
1. Thoroughly inspect jack for damage or wear before each use. Briefly test operation of unloaded jack before using to lift. If
jack is damaged or is malfunctioning DO NOT LIFT ANY LOAD until the problem is corrected.
2. The Vehicle manufacturer's owner's manual should be consulted prior to the lifting of the vehicle. It will advise safety
precautions, jacking procedure, vehicle weight, recommended jack type, and location of jack support areas on vehicle. The
working load limit of the jack is 3000 kg. NEVER EXCEED WORKING LOAD LIMIT OF THE JACK.
IMPORTER
:
PW TECHSAM Woch Sp. J.
ul. Warszawska 131
20-824 Lublin
www.quatros.eu
a
a
tel. 81 444-63-73
tel. 81 443-08-12
fax 81 458-38-19
e-mail: techsam@quatros.pl