Jenex V2 AERO 150 Instructions

Video instructions for using the Tire Station available on our website at www.jenex.com
Included: Tire Station base with attached bearing support platform, 6mm wheel center bolt, 2 black spacers, 3/8" x 5" rear support
platform bolt, large tire iron, small tire iron
For tire lubrication, purchase some Murphy's Oil Soap any other good tire lubricant, and a small brush.
F1
Mix some water and Murphy's Oil Soap, or other tire lubricant.
V2 AERO 150 TIRE STATION INSTRUCTIONS
You will also need some talcum powder.
The Tire station shown should be
mounted on a bench as close to the
edge as possible. The Tire Station
must be securely fastened to the
work bench via the 4 screw holes.
For a less permanent fixture, you can
mount the Tire Station to a plank of
wood, then clamp the plank to the
edge of a strong table or sawhorse
REMOVAL OF THE TIRE AND TUBE
f the tire is inflated, remove the air by pressing the
I
valve as shown in F1.
Place the wheel on the Tire Station with
the valve stem facing down. Use the long
6 mm bolt with the black spacers to fasten
the wheel assembly to the station by hand
threading
receptacle at the bottom of the Tire Station,
as shown in F2. When the tire has been
mounted on the rim for a long time, it has a
tendency to stick to the rim. To make it
easier to remove the tire with the tire irons
we first want to loosen the tire from the rim.
F3
Jenex, Inc / V2 Roller Skis
when in use.
the bolt into
Lift the bearing support platform and insert the 3/8" x 5 bolt into
the slots behind the support platform, so the bearing support
platform stays vertical. See F3. With the bearing pushing the
tire away from the rim, rotate the wheel 360 degrees. As you
rotate, brush the lubricant on the tire as shown in F3. For best
penetration, brush the lubricant onto the tire close to the
bearing as you rotate the tire. Next, remove the wheel and flip
the wheel so the valve stem is facing up, and repeat the
procedure. Pull the support plate forward slightly to release
the pressure on the back bolt and remove the 3/8 x 5 bolt
from the slots. Let the support plate lay flat on the table.
www.jenex.com
the female
7/20
F2