Johnson Plastics Plus SUBPB6 Tech Tip

WHITE CERAMIC PET BOWL
SUBPB6 | SUBPB7

Recommended Equipment

•
Convection Oven
•
Quick Release Wrap (Pet Bowls)- SUBWRAP6
•
Heat Tape
•
Room-temp Water for cooling

Recommended Settings

•
Time: 13-15 minutes
•
Temperature: 400°F
•
Pressure: Moderate

General Sublimation Instructions

•
Preheat heat the convection oven to 400°F. Set heat time to 13-15 min.
•
Print and cut out image on sublimation transfer paper. Place image face down
onto the side of the pet bowl. Secure the image with transfer tape.
•
Place the Quick Release Wrap (SUBWRAP6) down on a tabletop and spread open
the silicone wrap so that it lays flat.
•
Place the pet bowl onto the silicone wrap so that the transfer paper is facing the
silicone wrap and is also centered on the wrap in between the two metal clasp
ends.
•
Carefully wrap the Quick Release Wrap around the bowl, being careful not to slide
the silicone wrap on the bowl. Bring the two metal clasp ends together and secure
them together, locking the Quick Release Wrap shut around the bowl.
o See the SUBWRAP6 Tech Tips for full directions on how to use the Quick
Release Wrap.
•
Place the pet bowl with attached transfer and Quick Release Wrap into the
preheated convection oven. Make sure to place the pet bowl in the oven with the
open end face down.