Advertisement
Quick Links
HOVA BATOR
PARTS
Unpack the incubator from box. Check
for the components listed below.
Top with heat element, fan,
pilot light, thermostat, &
vent plugs installed.
Hova-Bator Bottom
Wire Floor
Plastic Liner
Owl Clips x 4
1825 Thermometer
ELECTRONIC THERMOSTAT
SETUP
Owl Clip
Owl Clip
NOTICE: Humidity troughs should be fi lled with cool tap water. Careful to avoid spilling
excess water outside of trough as it will eff ect humidity. Humidity should be between
45 and 55% for SETTING and 55 to 65% for HATCHING. Setting the humidity above
65% is not recommended as it may cause condensation to form on the windows and
can decrease hatch percentage.
Plug the cord set into the appropriate wall socket. The fan should then run and the
small heat indicator light on the thermostat box should be lit. Allow the incubator
to warm up for one hour. When the light begins blinking regularly, the incubator
is nearing its set point.
CIRCULATED AIR
MODEL 2362E
MADE IN USA
Unpack the incubator from the box
and set aside the thermometer
and wire floor. Remove the top
half from the bottom.
Floor to Plastic Liner with Owl
Clips then place fl oor and liner in
Hova-Bator Bottom. Arrange the
plastic floor as shown using the
water troughs and turner power
cord notch as reference. In most
Notch
climates, fi ll trough #1 (highlighted
in yellow) with water. Surface area,
not depth, determines humidity;
refi ll trough as necessary to prevent
it from drying out.
Attach Wire
Advertisement
Summary of Contents for GQF HOVA-BATOR 2362E
- Page 1 HOVA BATOR ELECTRONIC THERMOSTAT CIRCULATED AIR MODEL 2362E MADE IN USA PARTS SETUP Unpack the incubator from box. Check for the components listed below. Unpack the incubator from the box and set aside the thermometer and wire floor. Remove the top Attach Wire half from the bottom.
- Page 2 LOCATION An Incubator is designed to bring normal room temperature to the desired temperature. Room temperture of 60°F. or below will reduce the temperature in the incubator. Room temperature change of 10°F. or more will change temperature in incubator & is more pronounced below a temperature of 70°F. The location of the machine is important to successful operation.
- Page 3 AUTOMATIC TURNER Set up incubator as shown on page 1. If you are using the automatic egg turner, place it on the wire fl oor in the bottom of the incubator. The turner motor uses metal gears for additional strength when turning heavy loads. These gears can emit noise during normal operation.
- Page 4 LIMITED WARRANTY GQF Manufacturing Co., Inc. guarantees against defect for a period of 1 year from date of purchase. This warrantee is void for product more than 3 years old when not sold direct from GQF to the consumer. Notify GQF Mfg. Co. of any defective items, giving catalogue number and name of item and what is wrong with item. Send copy of invoice showing date of purchase.
Need help?
Do you have a question about the HOVA-BATOR 2362E and is the answer not in the manual?
Questions and answers