Advertisement
Quick Links
BOTTLE CRUSHER
Model : Oppressor GLS & GLC
INSTRUCTION MANUAL
IMPORTANT!
PRIOR TO OPERATION ALL USERS MUST READ THE
ENTIRE INSTRUCTION MANUAL
Expleco Ltd has an ongoing development programme and the product
pictured may differ slightly in appearance.
Specifications are subject to change without notice.
Advertisement
Summary of Contents for Expleco Oppressor GLS
- Page 1 Model : Oppressor GLS & GLC INSTRUCTION MANUAL IMPORTANT! PRIOR TO OPERATION ALL USERS MUST READ THE ENTIRE INSTRUCTION MANUAL Expleco Ltd has an ongoing development programme and the product pictured may differ slightly in appearance. Specifications are subject to change without notice.
- Page 2 PRODUCT. 1. This machine is designed to crush glass bottles ONLY 2. Do not use the Oppressor GLS or GLC for any other use. 3. The machine is not intended for use by young or infirm persons. 4. Children or visitors should be kept well away from the machine and should not be permitted to handle the machine or power cord.
- Page 3 10mm Zinc Cap Screw located on the lower jack section. This will ensure that the bucket is properly sealed. To ensure seal only use the Expleco Bucket !! Bottle Jam 1. On the rare occasion that a bottle jams in the feed in chute or stalls the motor , carry out the following procedure.
- Page 4 3. If visible dust is still coming from the main inlet or filter the primary filter will need replacing. Please contact Expleco or the machine supplier for supply of replacement primary filter. Bearing and Jack stand grease.
-
Page 5: Troubleshooting
2. Bucket seal leaking stop bolt on lower jack leg. 2. replace bucket seal. 3. Incorrect diameter bucket 3. replace with Expleco bucket. Dust is visible from inlet 1. Full Bucket 1. empty bucket and/or filter 2. - Page 6 Expleco Limited will at its own option make good, replace the complete machine (or defective component) with the same or similar product, or...
- Page 7 Jack handle must be pushed back until nearly vertical and then released. This will ensure that the bin properly sealed. To ensure seal only use the Expleco 20 Litre Bucket !!
- Page 8 IMPORTANT PLEASE READ BEFORE ASSEMBLY Chute Refit • Refit main chute using bolts found in hinges. Make sure 10mm washers are reinstalled each side of hinge and 8mm washer is installed between nut and 10mm washer. Filter Refit • Push filter down firmly so that tube presses on white pre filter disc and tighten with a screwdriver.
- Page 9 T: 021324216...
Need help?
Do you have a question about the Oppressor GLS and is the answer not in the manual?
Questions and answers