Advertisement
Quick Links
General Instructions For Use & Safety: 40cc Big Bore Engine
Thank you for choosing Bartolone Racing Products for your RC needs. We strive to build the
best in class engines in quality and performance. Please read carefully and follow all applicable
safety and tuning guidelines to ensure many hours of trouble-free, safe operation
Safety:
1) Operation
Due to the size and weight of 1/5 scale and larger RC vehicles, it is recommended to operate
them only in a controlled environment such as a track facility. They should never be driven in
public spaces such as school yards, parks, roads or highways and anywhere crowds of people
may gather, as loss of control could cause grave bodily injury. As an added precaution, we
recommend installing a remotely operated safety kill switch on your new engine prior to
installation in your RC vehicle. Always refer to the manufacturers instructions for use before
operating any RC vehicle.
2) Fuel
Your new engine runs on a 26:1 ratio mix of gasoline and 2-stroke oil. Due to the highly
flammable nature of gasoline, you should never mix, fill or run your engine near open flame or
while smoking, as this could cause the fuel to ignite and cause injury to yourself or others.
Additionally, gasoline powered engines produce toxic carbon monoxide gasses and as such
should only be operated in wide open, well ventilated areas. Failure to do so could result in the
inhalation of the toxic carbon monoxide fumes.
Made in the USA!
.
Advertisement
Summary of Contents for BARTOLONE ENGINES bb942
- Page 1 Made in the USA! General Instructions For Use & Safety: 40cc Big Bore Engine Thank you for choosing Bartolone Racing Products for your RC needs. We strive to build the best in class engines in quality and performance. Please read carefully and follow all applicable safety and tuning guidelines to ensure many hours of trouble-free, safe operation Safety: 1) Operation...
-
Page 2: Initial Start-Up
Operating Your New Engine: 1) Fitment Your new engine is equipped with a Walbro 1107 carburator and a BPMR7A NGK spark plug. The initial settings on the carburator sould be 2 turns out(top/high end needle) and 1.5 turns out(low/bottom end needle). Check to ensure the spark plug is tight and the carburator is adjusted correctly before moving to the next step! 2) Fuel/Oil Mix Ratio This new engine MUST be run on pre-mixed fuel. -
Page 3: Maintenance
6) Maintenance Check spark plugs often, replace as required. Check, clean and replace air filters often as any dirt entering the engine due to a dirty or compromised filter may cause irrepirable damage. Primer Bulb Fuel Inlet Choke Lever High/Top End Needle Low/Bottom End Needle Idle Screw... -
Page 4: Warranty & Limits Of Liability
Pull Start Cord Warranty & Limits of Liability: Bartolone Racing may @ its’ discretion repair or replace items to have been deemed defective in material or workmanship. Damage to the product or mating parts caused by improper use, installation, tuning or runaway situations will not be covered as such under this limited liability warranty.