Advertisement
Quick Links
Advertisement
Summary of Contents for Peaksun Venus Series
- Page 1 Venus Series Installation Manual www.peaksun.com.cn sales@peaksun.com.cn...
- Page 2 solar panel clamp sheet 2pcs bracket hex nut M6X45 4pcs adapter 2pcs lamppost...
-
Page 3: Table Of Contents
1. Assemble the panel bracket accessaries Contents First assemble the photovoltaic panel bracket and the base of the adapter; Assemble the two parts together with the fasteners shown in the figure, and tighten the bolts with an Allen wrench. Pay attention to the outlet hole of the adapter base and the hole of the bracket. -
Page 4: Assemble The Bracket With The Panel
2. Assemble the bracket with the panel Put the bracket at the centeral back of the panel, insert the four positioning tenons on the bracket into the four positioning holes on the back of the panel, and tighten the four M6 bolts assembled on the bracket. sp an n er M 6 b racket h ex n u t M 6X 15 4p cs... -
Page 5: Drag Out The Panel Output Wire
4. Assemble the adapter accessaries. 3. Drag out the panel output wire: Pick up the adapter sleeve, pass the photovoltaic panel output wire out of the through hole on the sleeve, then close the sleeve to the adapter base, put M16 Drag out the panel output wire from the outlet holes on the bracket and the adapter base. -
Page 6: Install The Panel On The Lamp Post
5. Install the panel on the lamp post. D raw photovol out w ire After the pre-assembly of the photovoltaic panels is completed, the next step is to perform the installation ----- install the photovoltaic panel components on the assem bly adapter lamp post. -
Page 7: Lbc Installation
6. LBC installation. Drag out the panel output wire from the arm hole of the lamp post (the length of the output wire should be 0.15m --- 0.3m longer than the length of the arm post). Tools needed depend on the situation, no special reqiurements. ※... - Page 8 Align the adapter sleeve on the LBC with the arm of the lamp post and push it in until the bottom of the sleeve reaches the end of the arm; Slightly adjust the attitude of the LBC (the vertical symmetry plane of the LBC is perpendicular to the ground) adjust LBC position and tighten the mounting bolts on the outside of the sleeve.
-
Page 9: Adjust The Direction Of The Panel
7. Adjust the direction of the panel and fix it: Use your hand test the solar Adjust the direction of the panel to the ideal state, tighten the M16 bolts and panel placem ent spability nuts at the joints of the adapter, and then gently shake the panel by hand to check its firmness. -
Page 10: Connect The Wires
8. Connect the wires. Connect the waterproof plugs of the battery and the controller on LBC. Connect the circuit. Cover the panel with something light-proof material, if the light turns on, the whole installation completes. Connect battery and controller in...