Advertisement
Quick Links
Dedicated to supplying the best Slot Racing Products to Racers Worldwide
3 St James Terrace, Riding Mill, Northumberland, NE44 6ED England
Telephone 0044 (0) 1434-682475 - e-mail abslotsport@aol.com
BUILDING THE AB OG12 / Pro-Am CHASSIS
Thank you for purchasing the AB OG12 chassis. This chassis has undergone much development and we are
sure you will find this great chassis competitive and strong if you build it correctly.
Firstly lets take a look at the components. Using a dremel, take care cutting the components and trimming off
burrs from cut edges. Please read the instructions all the way through before picking up your tools!
We recommend AB Chassis Solder and flux to assemble this kit.
Front wheel
mount and pan
upstop plate
lock. x2
Front upstop &
front pan upstop
plate.x 2
Guide plate &
Guide spacer
plate.
Front & centre
Centre spine
mounts
Note;- You will find 3 different "rail options" for this
chassis, all of which are easily changed when finding
which set up is good for your track. You can go -
1) Single 0.032" rails
2) Single 0.042" rails, or
3) Twin 0.032" rails without having to modify the cuts in
the chassis frame, just the wire and tube you use, so
read the instruction sheet in full before you start
building to ensure you understand your options!
Generally for "scale" type track you may find the twin
0.032" rail option best.
web sites - www.abslotsport.biz - www.abslotsport.com
SKYPE - abslotsport
Pin tube mounts x 4
Pan Straps x 4
U.K. V.A.T. No. 910 9584 18
Motor box overlay
Pan cross bar
Pan cross bar
retainer
When trimming
components ensure
to only trim joining
sprags and not the
components
themselves
Front pan Upstops
X 2
Centre spine
rear mount &
motor box over-
lay front key
Advertisement
Summary of Contents for AB Slotsport AB OG12
- Page 1 U.K. V.A.T. No. 910 9584 18 BUILDING THE AB OG12 / Pro-Am CHASSIS Thank you for purchasing the AB OG12 chassis. This chassis has undergone much development and we are sure you will find this great chassis competitive and strong if you build it correctly.
- Page 2 Assemble the motor box overlay, rear pillar blocks and rear spine mount / motor box key and solder in place. Solder the Guide plate spacer and guide plate in place. Solder rails together a maximum of 0.50” Twin 0.032” rails. Both rails fit perfectly into the rear receports which are designed to take 1/16”...
- Page 3 Now it’s time to drop the Cross Bar into the centre slot in front of the rear spine mount. Note;- the cross bar “floats” in this slot. Do not solder the cross bar in the centre! Locate and solder the pan cross bar retainers in place. Take the four pan straps and trial fit through the holes in the crossbar.