Download Print this page

Advertisement

Quick Links

User Manual
Remote Controller
ESKY008085
Esky
FCC ID: 2AVDQ-ESKY008085
Shenzhen Zonda Hobby Co.,Ltd
Rm 609, Block A, Dachong Business Center, #9678 Shennan
Rd. Nanshan District, Shenzhen, China

Advertisement

loading

Summary of Contents for Zonda Hobby ECH6

  • Page 1 User Manual Remote Controller ESKY008085 Esky FCC ID: 2AVDQ-ESKY008085 Shenzhen Zonda Hobby Co.,Ltd Rm 609, Block A, Dachong Business Center, #9678 Shennan Rd. Nanshan District, Shenzhen, China...
  • Page 2 Aileron Trim Lever: Fine tuning the Aileron Control Power Switch: Push up to power on, push down to power off. Charging Indicator: ECH6 transmitter (RTF version) uses Alkaline Battery, so the transmitter charging function is not available. (Transmitter charging function is only available to LiPO batteries and NiMH batteries) Reverse Switches: Control direction of movement of servos connected to the receiver.
  • Page 3 ECH6 Transmitter Control Direction - Left hand throttle Mode2 Mode 2 Push the “Left Stick” up, the aircraft motor speeds up to make the aircraft go faster. When pushing the “Left Stick” down, the aircraft motor speeds down and slow down the aircraft.
  • Page 4 Aileron Trim Lever: Fine tuning the Aileron Control Power Switch: Push up to power on, push down to power off. Charging Indicator: ECH6 transmitter (RTF version) uses Alkaline Battery, so the transmitter charging function is not available. (Transmitter charging function is only available to LiPO batteries and NiMH batteries) Reverse Switches: Control direction of movement of servos connected to the receiver.
  • Page 5 ECH6 Transmitter Control Direction - Right hand throttle Mode1 Mode 1 Push the “Right Stick” up, the aircraft motor speeds up to make the aircraft go faster. When pushing the “Right Stick” down, the aircraft motor speeds down and slow down the aircraft.
  • Page 6 FCC Warning: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.