SECURELY S4i PERS User Manual

Turning the s4i PERS Alarm On
The On/Off button is recessed into the bottom of the panel as per the
diagram below. Ensure the power cable is connected correctly and the plug
pack is connected to a reliable power point and where the power supply
will not get knocked out. Fit the back cover on.
Backup battery
For assistance call Securely on 0800 865 865
Connect the power cable
and plug into a power
source. Then close the back
cover.
Turn the power switch
ON
S4i PERS User Guide
Shows power Shows communication
status status
· On: AC power · Green: if on, ready for call. If
connected blinking, message being sent.
· Blinking: Operating · Red: if on, failure in cellular
on battery. Mains network. If blinking, cellular
power failure reception is poor
· Off: no power · Orange: active conversation
Press to cancel
an emergency
call
Press to start
an emergency
call.
Right light:
Blinking: alarm in
progress
On: message
acknowledged
Shows problem
status
· On: malfunction in the
control panel or a
peripheral
· Blinking: supervision
lost, or low battery in a
peripheral
· Call the support centre
if this light is on for more
than 15 minutes