CanaKit RASPBERRY PI Quick Start Manual page 4

G S
ETTING
Broadcom CPU
DSI Display
Connector
MicroSD
Card Slot
(On Underside)
1. If you have a case, start by installing the Raspberry Pi inside the case.
You can find video instructions for CanaKit Raspberry Pi cases at:
2. Insert a pre-programmed MicroSD card into the MicroSD card slot on
the bottom side of the Raspberry Pi.
3. Connect a USB keyboard and mouse to the USB ports.
4. Connect a HDMI monitor or TV to the Raspberry Pi using a HDMI cable.
Ensure your monitor or TV is turned on and that you have selected the
correct input.
5. If you intend to use an Operating System other than Raspbian, connect
the Raspberry Pi to your network using an Ethernet cable. If a wired
Internet connection is detected during the first boot, you will be presented
with additional choices of Operating Systems to install.
3
TARTED
40-Pin GPIO Header
5V MicroUSB HDMI
Port
www.canakit.com/pi-case
Cana
4-Pole 3.5mm
Audio & Composite Video
CSI Camera Connector
Kit
USB
Ports
Ethernet
Port