RANCEO CL25 Instruction Manual

MADE FOR BUILDERS
Connect the See Snake directly to 230V.
Flexible work light,both for outside and inside use.
1500 Lumens per meter and easy to operate.
CL25
Instruction manual - 1/2

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL SAFETY INSTRUCTIONS
!

WARNING!

Do not operate flexible light
while it is coiled
!

DO NOT!

Do not bend the See Snake to a
diameter less than 25 mm.
• LED Strip Light only can be bent vertically not horizontally
• Unbalanced voltage drop can cause hazardous overload and damage the flexible light
• Do not route the cord or flexible lighting through walls, doors, windows, or any like part of the building structure
• Do not cover this product as the covering may cause the flexible light to overheat, melt, or ignite.
• Secure this flexible light using only the hangers or clips provided. Do not secure this product or its cord with staples, nails,or like means that may
damage the insulation or permanently attach to the building structure.
• Follow instructions carefully when splicing flexible light sections or attaching power cords. Ensure that all connections, including the end cap on
the last segment,are properly installed with dielectric grease and shrink tube to preclude the entrance of water (outdoor applications)
• DO NOT EXCEED THE MAXIMUM NUMBER OF EXTENSIONS OR FLEXIBLE LIGHT LENGTHS PERMITTED BY THE MARKING.
RANCEO
Copenhagen, Denmark
+45 38 71 69 59
!
These products may represent a possible
shock or fire hazard if improperly installed or
attached in any way.
Products should be installed in accordance
with these instructions, current and
electrical codes.
Do not fold a sharp corner
on the See Snake.
ATTACH / DETACHED 230 V cable from The See Snake
See all products on
ranceo.com
See Snake
LED STRIP LIGHT
CONSTRUCTION LIGHTNING
25 METER
To reduce the risk of fire, electric shock or
injury to persons, make sure that the
electrical power to the fixture is disconnected
at the source prior to installation or any
Do not bend LED Strip Light
on a horizontal plane.
Distributor and manufactor:
SCANLICO DENMARK A/S
Marielundvej 46E - 2730 Herlev, Denmark
+45 38 71 69 59
info@scanlico.dk
!
servicing.
Do not put excessive pressure
on the surface of the strip light
(e.g. glass/acrylic panes etc.).