Summary of Contents for AG EQUIPMENT GNX2100TN
- Page 2 When preparing to clean the unit, switch off and disconnect the power supply from the wall socket. • If the power cord is damaged, it MUST BE replaced by an AG Equipment recommended service agent or a qualified electrician to avoid a hazard.
- Page 3 Slip the shelf into the guides on either side. Replicate for the remainder of the shelves. Operation Storing Food To get the best results from your AG Equipment product, follow these instructions: • Ensure operating temperature is reached before beginning storing food in the unit. •...
- Page 4 “Wipe on, wipe off.” as the famous saying goes. Immediately clear any excess soup residue with water, then wipe dry the area(s) you have just cleaned. • When cleaning, be mindful of sharp edges on the unit. • If required, please contact AG Equipment for advice on a qualified service agent near you.
- Page 5 Stainless Steel Care To preserve a high finish on the stainless-steel surfaces of your AG Equipment unit. Please follow the instructions listed below: • DO NOT use abrasive products, such as scourers or scrubbing pads, etc... Use only soft cloths or non-abrasive products to clean with the grain of the steel and not against it.
-
Page 6: Troubleshooting
Troubleshooting If your AG Equipment appliance develops a fault, please check the following table before making a call to the Helpline. Fault Porbable Cause Action The appliance is not working The unit is not switched on Check the unit is plugged in correctly and switched on... -
Page 7: Electrical Wiring
Electrical Wiring Appliance are supplied with a 3 pin, moulded power plug. This plug is to be connected to a suitable mains socket. Appliance power socket is wired as follows. Live wire (coloured brown) to terminal marked L Neutral wire ( coloured blue) to terminal marked N Earth wire (coloured green and yellow alternatively) to terminal marked E Warning! The appliance must be earthed using a dedicated earthing circuit.
Need help?
Do you have a question about the GNX2100TN and is the answer not in the manual?
Questions and answers