Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for VALD SmartSpeed Pro
- Page 1 SmartSpeed Pro Quick Start Guide VALD V1 2021...
- Page 2 SmartHub ............................. 4 Software setup ......................4 SmartSpeed App .......................... 4 SmartSpeed Online ........................5 SmartHub setup......................5 Hardware setup ......................6 Run a session ......................7 Care ........................... 7 10 Health and safety information ..................8 VALD SmartSpeed Quick Start Guide...
- Page 3 Overview The SmartSpeed Pro system is the most comprehensive speed, reactive and agility training tool used by elite clubs, combines and academies around the world. Components The SmartSpeed Pro System consists of the following components: • 2 x Pro timing units ...
- Page 4 To charge your timing units, connect the units to the provided 12V daisy chain charger. The charging LED, located on the back of each Smartspeed Pro unit, will flash red when charging. The LED will turn solid red when fully charged.
- Page 5 SmartSpeed account details. These details are the same login credentials used to log in to the SmartSpeed app. SmartHub setup The SmartHub is the command centre for the SmartSpeed Pro system. It uses two in-built radio devices: • Zigbee - to communicate between timing units; and •...
- Page 6 Hardware setup Each SmartSpeed Pro timing gate consists of the following components: • 1 x timing unit • 1 x reflector • 2 x tripods To assemble a timing gate: 1. Assemble the tripods a. Loosen tripod knob and pull legs away from stem.
- Page 7 The following is recommended to ensure the protection of your SmartSpeed Pro system: • When not in use, store your SmartSpeed Pro system in the provided hard travel case. • In the case of wet weather, ensure the SmartSpeed system components are dry prior to storage.
- Page 8 • If Batteries will not recharge (batteries provided have a recharge life of 800 times), DO NOT ATTEMPT to change the batteries yourself. Instead contact VALD. Electronic devices Most modern electronic equipment is shielded from radio frequency (RF) signals. However, certain electronic equipment may not be shielded against the RF signals from the units.
Need help?
Do you have a question about the SmartSpeed Pro and is the answer not in the manual?
Questions and answers