Advertisement

PP600.1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PP600.1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Bass Habit PP600.1

  • Page 1 PP600.1...
  • Page 2: Safety Instructions

    Closely follow the advices, recommendations and safety precautions. Thank you for choosing Bass Habit! We hope you enjoy listening to your product as much as we have enjoyed creating it. SAFETY INSTRUCTIONS Do not expose this product to damp or moisture - doing so may result in fire, shock or...
  • Page 3: Installation

    INSTALLATION Turn off the audio system and other electronic devices before you start. Disconnect the negative (-) lead from your vehicle’s battery. Choose a mounting location in an area where the amplifier will not be damaged, and where the amplifier is not covered up. Mount the amplifier so that it remains dry - never mount an amplifier outside the vehicle or in the engine compartment.
  • Page 4 POWER/SPEAKER CONNECTIONS (FIG 1 & FIG 2) To get the very best performance out of your Bass Habit amplifier, carefully follow the instructions below: Power Connection (+12V): Connect the 12V power supply cable after all other leads have been connected and secured.
  • Page 5 FIG 1: POWER CONNECTION FIG 2: SPEAKER CONNECTION...
  • Page 6 FRONT PANEL (FIG 3 & FIG 4) Bass Habit PP600.1 is a Class D amplifier and can be used for speakers (e.g. Subwoofer) in the range between 32-300 Hz. While listening to music, adjust the gain/crossover/subsonic/bass boost for the least perceived distortion from the speakers, allowing the speaker to reproduce as much bass as possible.
  • Page 7 For a normal setup the subsonic should be adjusted to the 0-degree setting. Remote Level Control (REMOTE) PP600.1 has a remote level control included for adjustment of the input level from the listening position. Connect the remote-control cable using the REMOTE input jack on the amplifier.
  • Page 8 FIG 4: FRONT PANEL BRIDGE OUT Bridge a second PP600.1 using an RCA jack cable LINE INPUT R Source signal input right BRIDGE IN Bridge a second PP600.1 using an RCA jack cable LINE INPUT L Source signal input left...
  • Page 9: Troubleshooting

    Music lacks bass and attack Check speaker connections for proper polarity. SPECIFICATIONS: PP600.1 • Number of channels: 1CH • Power output (RMS) @ 1 ohm: 1x600W • Power output (RMS) @ 2 ohm: 1x350W • Power output (RMS) @ 4 ohm: 1x180W •...
  • Page 10: International Warranty

    WARRANTY All Bass Habit products carry a full warranty depending on the conditions in the country where it is sold. The Warranty is valid from the date of the original receipt as proof of purchase. The warranty does NOT cover: •...

Table of Contents