Microtrac S3500 Operation And Maintenance Manual page 2

Copyright, Notices, and Trademarks
Printed in U.S.A. – © Copyright 2004 by Microtrac Inc.
1/04
While this information is presented in good faith and believed to be accurate, Microtrac disclaims
the implied warranties of merchantability and fitness for a particular purpose and makes no
express warranties except as may be stated in its written agreement with and for its customer.
In no event is Microtrac liable to anyone for any indirect, special or consequential damages. The
information and specifications in this document are subject to change without notice.
®
Microtrac is a registered trademark of Microtrac Inc.
CE Conformity: This product is in conformance with the protection requirements of the
following European Council Directives: 89/336/EEC, the EMC directive and 73/23/ECC, the Low
Voltage Directive. Conformance of this product with any other "CE Mark" directive shall not be
assumed.
WARNING
This is a class A product. In a domestic environment this product may cause radio interference in
which case the user may be required to take appropriate measures.
CAUTION
This product is intended for use in environments defined by IEC Pollution Degree 2, generally
what would be expected in an office or laboratory. Industrial environments or those that may
result in conductive contamination entering the device, or contamination that may become
conductive when combined with condensation, are not suitable for the equipment.
SYMBOL DEFINITIONS
!
This CAUTION symbol on the equipment refers the user to the Product Manual for
additional information.
WARNING, risk of electric shock. This symbol warns the user of a potential shock hazard
where voltages greater than 30 Vrms, 42.2 Vpeak, or 60 Vdc may be accessible.
Protective earth terminal. Provided for connection of the protective earth (green or
green/yellow) supply system conductor.
Laser Radiation. Refer to Product Manual before removing or opening any covers.
Microtrac Inc.
nd
12501-A 62 Street North
Largo FL 33773
(727) 507-9770
ii Microtrac S3500 Particle Size Analyzer Operation and Maintenance 9/03