Motikom MPlus User Manual

Motikom MPlus User Manual

Multipurpose motorcycle communication neckband

Advertisement

Quick Links

MPlus
RA1000S
Multipurpose Motorcycle
Communication Neckband
User Manual
FCC ID:2AU2ARALP9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MPlus and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Motikom MPlus

  • Page 1 MPlus RA1000S Multipurpose Motorcycle Communication Neckband User Manual FCC ID:2AU2ARALP9...
  • Page 2: Table Of Contents

    Table of contents 1. General Information .............................3 Reading and storing the user manual ............................3 Proper use ......................................3 Explanation of symbols ...................................3 2. Safety instructions ..............................4 3. Device overview ..............................6 4. Checking the device and package contents .......................7 5. Charging the device ..............................7 6.
  • Page 3: General Information

    IP67 The device is protected from the ingress of dust and water. This user manual accompanies this MPlus, Multipurpose Motorcycle Communication This mark indicates compliance with Neckband (hereafter referred to as the technical and design requirements “device”), and contains important information...
  • Page 4: Safety Instructions

    Safety instructions WARNING! Risk of injury! − Excessive sound pressure from WARNING! Risk of explosion or leakage! earphones and headphones can − The built-in rechargeable battery may cause hearing loss. present a fire or chemical burn hazard − Avoid using the device at high volume if mistreated.
  • Page 5 may cause harmful interference to radio person with similar qualifications must communications. However, there is no replace it to avoid risks. guarantee that interference will not occur − Only parts that comply with the original in a particular installation. device data may be used for repairs. This −...
  • Page 6: Device Overview

    Device overview Components Ear tips (left and right), 3 sets (Size: S, M, L) EcoFits Ear Gel, 2 sets (Size: S, L) Earpieces (left and right) LED lights (backside) Neckband Microphone Microphone connector USB charging port (underside) POWER HDNC Boom microphone 10 Attachment flap 11 Hook-and-loop fasteners (2 sets) MODE...
  • Page 7: Checking The Device And Package Contents

    Checking the device and 3. The red LED lights will turn off when the device is fully charged. Unplug the USB cable from the USB power package contents source and disconnect the USB cable from the USB 1. Take the device out of the packaging. charging port of the device.
  • Page 8 2. Attach one side of a pair of hook-and-loop fastener [11] Wired microphone to the attachment flap. Note: You can adjust the length of the cable extending Note: Attach the wired microphone to the helmet with outside of the helmet by snapping the cable into the a pair of hook-and-loop fastener.
  • Page 9: Operation

    Operation 6. Put on your helmet and connect the microphone to the microphone connector [7] on the neckband. General controls • Use the buttons and knobs below for operation. • During setup and use, voice prompts are available to notify you of current operation status.
  • Page 10: Power On Or Off

    “Phone pairing”. This feature (remote control pairing) is still under development. 3. On your mobile phone, select “Motikom - Plus” from • If you are wearing the device around your neck with the list of available devices for pairing.
  • Page 11: Notes On Pairing

    3. Press MFB button and then release the button when End a call. Turn MODE anticlockwise and you hear the voice prompt “Pairing mode”. then release. The device will start searching for the third party neckband and pair with it. MODE Controls for intercom calls with the third party neckband must be performed on this device.
  • Page 12: Activating Voice Control Of Your Mobile Phone

    Handling two phone calls End the current phone Turn MODE anticlockwise and call and switch back to then release. Turn MODE clockwise and then Answer a new incoming intercom. call and put the current release. call on hold. MODE MODE 7.10 Activating voice control of your Reject a new incoming Turn MODE anticlockwise and...
  • Page 13: Controlling The Media Player Of Your Mobile Phone

    • The last paired device is regarded as the 1st intercom Go to next track. Turn MODE clockwise and then friend. Press MFB button once to connect or release twice. disconnect the intercom communication with the 1st intercom friend. • The first paired device is regarded as the 2nd intercom friend.
  • Page 14: Hybrid Dynamic Noise Cancellation System

    • Press HDNC to cycle through the levels. Press the button once to go one level up or twice successively to 7.16 More product information go one level down. Visit www.motikom.com for more information. Active Noise Cancellation levels LED lights Level 1: Ultimate noice cancelling level...
  • Page 15: Storage

    10. Storage Poor sound Make sure your device is within the quality or device’s Bluetooth range (10 m). • Store the device in the carrying case [15] and in a dry, distorted sound. Move your device closer to the clean and dust-free location. device.
  • Page 16: Disposal

    The full text of the EU declaration of conformity is available or in a retail outlet so that they can be disposed of in an at the following internet address: www.motikom.com environmentallyfriendly manner. Bring the device, in their entirety, (together with the The Bluetooth max.
  • Page 17 FCC statements: The device has been evaluated to meet general RF exposure requirement, The device can be used in portable exposure condition without restriction Federal Communication Commission (FCC) Radiation Exposure Statement Power is so low that no RF exposure calculation is needed. This device complies with part 15 of the FCC rules.

This manual is also suitable for:

Ra1000s

Table of Contents