1
Controllo componenti e materiale montaggio letto - Control of the bed assembly materials and parts
1. dopo aver disimballato tutto il materiale, verificare che corrisponda esattamente al
materiale rappresentato in disegno ed elencato nella tabella che segue.
A
I
3 TESTINE
F
A TASSELLO
BLIND NUTS
CHIMICO
(screws with
a chimical
expanding plug)
2
1. considerando un materasso di altezza 170 mm, indi-
viduare sulla tabella l'altezza ottimale del letto (H).
1. considering a 170 mm high mattress, find the ideal
height of the bed (H) on the table .
rev. 081020
Attrezzi necessari - Required tools
18 VITI
G
H
B
WASHERS
PER VITI M6
FOR M6 SCREWS
Determinazione altezza letto - Bed height setting
2. dal disegno individuare il foro sulla gamba telescopica
(1° foro, 2° foro, ...) corrispondente alla altezza scelta.
2. from the drawing, find the hole on the telescopic leg (1
hole, 2
hole, ...) that corresponds to the chosen height.
nd
FLUTTUA C
1. after having unpacked all the materials, make sure that they correspond with the materi-
als illustrated in the diagram and listed in the following table.
5
E
fermacavo
adesivi
adhesive
cable holders
ISTRUZIONI DI MONTAGGIO
ASSEMBLY DIRECTIONS
3. definire l'altezza (h) di foratura a muro su cui andrà fis-
sato il profilo a 'T' con il pannello proteggi materasso.
3. define the drilling height (h) on the wall to which the
st
T-shaped bar with the mattress protective panel will be
fixed.
L
WASHERS
PER VITI M6
FOR M6 SCREWS
page 1