Advertisement
Quick Links
Advertisement
Summary of Contents for Rainbow Treecare HTI 2000
- Page 1 Application, Care, and Troubleshooting Guide Contains: 1. Instructions for: a. Prior to Use b. Application c. Application tips 2. General Care and Storage 3. Maintenance 4. Trouble Shooting Tech support: www.treecarescience.com | info@treecarescience.com | 877-272-6747...
-
Page 2: Preparing For Application
Overview of Your HTI 2000 The HTI 2000 is a lightweight, accurate soil injector that avoids the need for a flowmeter Specifically designed to apply Cambistat, this soil injector can also be used to apply Xytect, Lepitect, Transtect, and other tree health products where accuracy is critical. -
Page 3: Application Tips
5. Fill HTI 2000 by holding down the fill button until the desired volume is achieved 6. Hold down the inject button to apply product to the soil. Volume meter will show Space application sites progress of ejected product. - Page 4 Maintaining Your HTI 2000 General Care and Upkeep 1. DO NOT run fertilizers through HTI 2000. They are too Daily Cleaning abrasive on the aluminum and will rapidly clog the filter. 1. At the end of the application day, run 2000ml of water through the HTI 2000 using the same fill and 2.
-
Page 5: Troubleshooting Guide
Troubleshooting Guide POSSIBLE CAUSE SUGGESTED SOLUTION INJECTION CYLINDER NOT INJECTING OR INJECTING AT SLOW RATE Too low of pressure 1. Check the hose connecting the backpack or pump to the HTI to make sure that it is not kinked. 2. Make sure that the ends of the hoses located within the manifold are not loose, tighten them if need be. - Page 6 Mix Rates For HTI 2000 Soil Injector Always refer to product label for approved uses, rates, and precautions The HTI injector distributes 250ml per injection and is intended to apply 1 injection site per 1” DBH. Cambistat® Mix Rates: • 11:1 Water:Cambistat ratio: To mix 1 gallon of ready to use solution = 3470 ml of water to 315 ml of Cambistat Transtect™...