Download Print this page
Bynolyt Searanger III Quick Start Manual

Bynolyt Searanger III Quick Start Manual

Advertisement

Available languages

Available languages

Quick Links

Bynolyt Searanger III 7x50
How to use your binocular.
IDP adjustment
Set the interpupillary distance by grasping the body and bending it until you can
see one circle of view. The setting for your eyes will be indicated on the IPD
Scale.
Focusing
1.
close your left eye and sight an object with your right eye. Focus the
binocular by rotating the right focus Wheel until the image is Sharp and
clear.
2.
Open your left eye, close your right eye, focus the binocular by rotating
the left focus wheel until the image is sharp and clear.
Rubber fold down eyecups
Fold down for use with eyeglasses and fold up for use without eyeglasses. They
provide comfort and promote viewing ease.
How to care for your binocular
-
keep lens covers (that come with your binocular) on the lenses when
your binocular is not in use
-
When wiping the lenses, use the lens cloth that comes with the
binocular, or a soft, lintless cloth.
-
To remove any remaining dirt or smudges, add one or two drops of
isopropyl alcohol to the cloth.
-
Store your binocular in a moisture-free area.
Very important!
Never attempt to clean your binocular internally or try to take it apart.
CAUTION!
Viewing the sun can cause permanent eye damage.
Do not view the sun with this binocular or even with the naked eye.
How to use the built-in compass
The Bynolyt Searanger III 7x50 compass model comes with built-in LED
compass illuminator for use at night and in low light conditions. (Incidentally, the
compass is built into the left
tube of the binocular and the
pushbutton control for the
light and the battery are
located in the right tube. This
was done to minimize the
chance
that
electrical
interference
might
affect
compass performance.)
When
the
ambiance
light
does not permit you to see
the compass heading clearly,
press the button at the right
tube. If the light is dim or does
not come on, replace the
batteries. If the light does not
operate after replacing the batteries, please contact the Bynolyt dealer nearest
you.
You can read on the compass a number. This number indicates the target
direction in degrees. North is 360 °, south 180 °, 270 ° West and East 90.
It should be noted that the magnetic north pole, not the astronomical north
direction is given. (The magnetic north pole is dependent to the position on the
earth).
How to change batteries
To change the battery, use a thin coin to remove the battery cover by turning ti
counter-clockwise. Remove the two batteries, the batteries have a (+) on the
front and a (-) on the back. Be sure to insert the new batteries with (+) in the
same direction. Replace the battery cover by turning it clockwise.
Battery equivalents
Manufacturer
Type
Toshiba, Maxell, Panasonic
LR 43
Varta
V 12 GA
Duracell
D 188 AB

Advertisement

loading

Summary of Contents for Bynolyt Searanger III

  • Page 1 How to use the built-in compass Bynolyt Searanger III 7x50 The Bynolyt Searanger III 7x50 compass model comes with built-in LED How to use your binocular. compass illuminator for use at night and in low light conditions. (Incidentally, the compass is built into the left...
  • Page 2 How to use the reticle. Bynolyt Searanger III 7x50 nederlands The vertical scale (reticle) visible through the left half of the binocular, above the Hoe gebruikt u uw verrekijker. compass display, allows you to calculate distance to an object if you know its height, or to calculate the height of an object if you know its distance from you.
  • Page 3 Het dradenkruis is zichtbaar door de linker helft van de verrekijker. Het De Bynolyt Searanger III 7x50 wordt geleverd met een LED kompas. Dit kompas dradenkruis helpt u bij het bepalen van de afstand van u naar een voorwerp. Om is speciaal voor gebruik tijdens de schemer en nacht.

This manual is also suitable for:

00831010