Download
Share
Print this page
Fontanella CWM-01 User Manual
  1. Manuals
  2. Brands
  3. Fontanella Manuals
  4. Coffee Maker
  5. CWM-01
  6. User manual

Fontanella CWM-01 User Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
USER MANUAL
Fontanella
A Q U A | S P A R K L I N G | C A F É

Advertisement

loading
Need help?

Need help?

Do you have a question about the CWM-01 and is the answer not in the manual?

Questions and answers

Summary of Contents for Fontanella CWM-01

  • Page 1 USER MANUAL Fontanella A Q U A | S P A R K L I N G | C A F É...

  • Page 2: General Advice

    45°C. It is forbidden to modify or to attempt to modify any features of the Fontanella. Doing so can result in serious injury and voids the warranty.
  • Page 3 Fontanella is NOT a toy. Keep out of reach of children. Close supervision is necessary when Fontanella is used near children. Electrical Hazards Only connect Fontanella to a power outlet with a grounding system. The voltage must correspond to the value indicated in the technical data section.
  • Page 4 Caution: Always keep the CO2 Canister away from any heat source and out of direct sunlight. Caution: Please DO NOT transport the Fontanella with the CO2 Canister in place. Caution: Please DO NOT tamper with the CO2 Canister in any way.

  • Page 5: Technical Data

    10 - 45 °C (50 - 104 °F) DECLARATION OF CONFORMITY Fontanella complies with the following standards: For parts that come into contact with food substances, it complies with the prescription of the EEC directive 89/109 and of the Law by Decree n.108 del 25/01/92;...

  • Page 6: Intended Use

    Note: USER MUST FOLLOW STEPS BELOW IN SEQUENCE: 1. Insert the Bio-Filter Please open the left side door on the Fontanella. Affix the Bio-Filter provided to the Filter Connector. Please make sure the Bio-Filter is securely locked and firmed with the Filter Connector.
  • Page 7 NOT to be connected to a mains water supply in Australia. Caution: In places where the Fontanella is approved to be installed to a mains water supply, always verify that the inlet water is of a controlled origin (drinkable). Installation must be done strictly by a qualified technician.
  • Page 8 OPERATION OF FONTANELLA Power On Plug in Fontanella to mains power inlet. Turn on the Main On / Off Switch at the back of the Fontanella. Then switch on the unit with the ON/OFF Button located on the top right of the unit. You will notice that the LED in the Control Scroll will light up Blue or flash RED according to the symbol on which it is positioned.
  • Page 9 (depending on quality of water used). Bio-Filter Alarm If the Fontanella unit emits an audible intermittent alarm and the red LED in the left side panel starts flashing with a softly siren, change the Bio-Filter located directly underneath. Unscrew the Bio-Filter in the left side compartment and replace.
  • Page 10 To adjust and set the amount / dose of Still Ambient Water, Cold Water and Hot Coffee, select the desired icon / beverage by rotating the Control Scroll, press and maintain a continuous pressure on the Push Button. Fontanella will commence dis-...
  • Page 11 Control Scroll, the Red LED Light on the icons will flash until the ideal temperature is reached. This usually takes up to 20 seconds to ensure the Fontanella always dispenses the ideal temperature for coffee and hot water.
  • Page 12 If a used coffee capsule is inadvertently left in the Fontanella for a certain amount of time, clean the Coffee Capsule Holder, Coffee Cup Stand with Coffee Bin and Waste Water Tray in accordance with the instructions given below.
  • Page 13 Caution: Please DO NOT insert any Coffee Capsule that is broken or pierced, or any used Coffee Capsule or into Fontanella, otherwise it may jam inside the coffee brewing system, causing damage to the Fontanella. Tip: Before inserting a new Coffee Capsule, press the Push Button (on coffee setting) and dispense and discard one dose (whether there is an existing used Coffee Capsule in place or not).
  • Page 14 To carry out periodic cleaning, use a soft moistened cloth with water or mild detergent to clean the housing of Fontanella. Never use wire wools or blades to clean to remove any possible dirt or scales. Always avoid using abrasive products to clean Fontanella.
  • Page 15 If any icon flashes continuously, turn the Control Scroll to the Cold Water Icon setting and then turn off the power for a few minutes, then switch back on and dispense a glass of cold water. If it continues flashing, call a Fontanella technician as it may be a thermostat issue.
  • Page 16 “Fontanella” CWM-01 12 Months Warranty Card Thank you for selection the Fontanella CWM-01. Fontanella provides a 12 month replacement warranty covering defects in materials or workmanship from the date of product purchase (in Australian market only). Equipment deemed to be defective in parts or workmanship will be repaired or replaced at the discretion of Novalink Holding Pty Ltd., at no charge, with the following exclu-...