Advertisement
SkyCamera
Trailer Installation &
Setup Guide
Important Note:
This guide ONLY applies to van trailers constructed from Duraplate. Intermodal container installs
should reference the Intermodal Installation & Setup Guide. Trailers with sheet & post construction
are not supported by SkyCamera.
Tools you'll need:
● Cordless drill (recommended: Power rating of at least 12V)
● 3/16" drill bit
● 1 3/4" (44mm) hole saw
● Bracket Placement Spacer (PN 190-0035)
● Riveter (rated to be able to pop 3/16 stainless steel rivets)
● 5/32" Pin-in-Hex Security Bit
● Ladder (please follow all OSHA ladder guidelines)
● Recommended: Safety gloves and protective eyewear
Camera placement:
Camera should be installed on the exterior of the container, left side as you look at the door end. The
top of the bracket should be roughly 3" from the top of the container wall and 18 - 36 inches from the
door end. Ensure that when the door is fully open, it does not pinch the camera.
Advertisement
Table of Contents
Summary of Contents for COMPOLOGY SkyCamera
- Page 1 Important Note: This guide ONLY applies to van trailers constructed from Duraplate. Intermodal container installs should reference the Intermodal Installation & Setup Guide. Trailers with sheet & post construction are not supported by SkyCamera. Tools you’ll need: ● Cordless drill (recommended: Power rating of at least 12V) ...
- Page 2 Attaching the camera: Once you've identified the location to install the camera, then: Drill the turret hole using the hole saw. This should go all the way through the Duraplate leaving a clean through-hole. 2. Insert the Bracket Placement Spacer into the hole. It should seat comfortably flat on the trailer surface. ...
- Page 3 Pair to Hub/gateway: Once the camera is securely attached to the container: Please refer to the given Hub/Gateway user manual for complete pairing instructions. Troubleshooting: Operation If hub/gateway pairing fails first try resetting the device by performing a magnet swipe to the right of the LED status indicator.
- Page 4 NOTICE : C hanges or modifications made to this equipment not expressly approved by Compology may void the FCC authorization to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of ...
Need help?
Do you have a question about the SkyCamera and is the answer not in the manual?
Questions and answers