JEFA TECH XR PLUS Configuration Instructions

THANK YOU FOR PURCHASING A JEFA TECH REPEATER XR PLUS!
How the JEFA TECH REPEATER XR PLUS System Works
The JEFA Tech Repeater XR PLUS consists of two main components:
 BULLET Outdoor WiFi Bridge and fiberglass antenna. It receives the signal from the
source WiFi. The antenna must be placed outside in a vertical position with the antenna
pointing straight up. Place it where it has a clear line of sight to the source WiFi.
 AIRGATEWAY Indoor Access Point – this is the black device with black antenna. It
should be placed inside in a convenient location. It broadcasts a private WiFi signal that
you will connect your devices to. You can connect any WiFi device to the
AIRGATEWAY including laptops, tablets, printers, gaming consoles, or video streaming
devices.
DO NOT PRESS RESET BUTTONS ON ANY OF THE EQUIPMENT
Doing so will put the system in a default state that will require technical support to fix.
The BULLET outside antenna and AIRGATEWAY are configured independently of each other.
The following IP addresses are associated with each of the devices:
BULLET - outside antenna / WiFi receiver – used for scanning for the WiFi network to repeat:
http://192.168.123.1
AIRGATEWAY – indoor access point – used for broadcasting your private WiFi network:
http://192.168.123.2
Their interfaces look almost identical so it is important to keep track of which device you are
configuring. 99% of the time you will be using
ABOUT CONFIGURING YOUR DEVICES:
Copyright JEFA Tech, Inc. - All rights reserved - http://www.jefatech.com
JEFA TECH REPEATER XR PLUS
IMPORTANT:
http://192.168.123.1
PAGE 1
CONFIGURATION
INSTRUCTIONS
only