Advertisement
Quick Links
Button Modes & Resets
Feed Mode
The Nero® will spin very slowly for 10 minutes (default setting) and then resume it's set mode.
1. Hold the button on the Driver for 2-5 seconds until the LED blinks white. The button LED will blink
white while in feed mode.
All Off
All connected Nero® pumps will stop.
1. Hold the button on the Driver for 6+ seconds until the LED fades out. The button LED will pulse white
while pumps are off.
To resume:
1. Press the button once.
Soft Reset
A soft reset restarts the device but retains the schedule and settings. To perform a soft reset:
1.
Unplug from power.
2.
Reapply power.
Nero
Quick Start Guide
®
Advertisement
Summary of Contents for AquaIllumination Nero 3
- Page 1 Button Modes & Resets Feed Mode The Nero® will spin very slowly for 10 minutes (default setting) and then resume it’s set mode. 1. Hold the button on the Driver for 2-5 seconds until the LED blinks white. The button LED will blink white while in feed mode.
- Page 2 OBTAINING WARRANTY SERVICE: If this product proves defective during the Warranty Period, contact C2 Copyright © C2 Development, Inc. AquaIllumination, myAI and the AI logo are registered trademarks of C2 Development, Inc. Nero is a trademark of C2 Technical Support (at the address listed below) for instructions on how to obtain warranty service.
Need help?
Do you have a question about the Nero 3 and is the answer not in the manual?
Questions and answers