Advertisement
Quick Links
Advertisement
Summary of Contents for GateCrafters GCLOCK
- Page 1 GateCrafters Automatic Gate Lock Instruction Manual GCLOCK...
- Page 2 Introduction The GateCrafters Automatic Gate Lock is designed to provide extra security and stability to your gate opener system. There are numerous different mounting methods on various types of gates. For that reason, no mounting hardware is included in this kit. For chain link gates, U-bolts, nuts and washers are used to mount the lock.
- Page 3 Mounting the lock and receiver Step 1: Remove the front end of the actuator that is attached to the gate bracket with a clevis pin and clip pin. Wire tie or clamp the front end on the gate to support it. This will enable you to swing the gate manually while installing the gate lock.
- Page 4 Step 5: Drill through the marks on the post and attach the receiver with the mounting bolts, washers and nuts that you have purchased. Step 6: The gate lock must now be permanently mounted to the gate cross member or gate surface. Make sure that lock is aligned with the receiver and mark holes on the gate through the upper and lower slots on the lock.
- Page 5 Typically a good source for this trigger will be one of the motor leads. See GateCrafters.com (type the word help into the search and click the first link to access gate opener specific wiring instructions for gate openers we carry) Alternate solution if an appropriate trigger is not locatable on the gate opener control board.