Advertisement
Advertisement
Table of Contents
Related Manuals for Rensair Q01B
Summary of Contents for Rensair Q01B
- Page 1 INSTRUCTION MANUAL Hospital-Grade Air Purifier MODEL: Q01B Rensair.com...
- Page 3 Hospital-Grade Air Purifier MODEL: Q01B 50Hz Air inlet perforations Air outlet perforations...
- Page 4 Hospital-Grade Air Purifier MODEL: Q01B Press to switch on/off. When switched on, the unit will start in AUTO mode. As the sensors determine the air quality, the fan speed will be set accordingly. NOTE: The UV-C lamp will be turned on by default. Once the air quality is deemed satisfactory, the unit will automatically switch to stand-by mode (under normal conditions, the unit will run for approx.
- Page 5 Choose the function buttons corresponding to the buttons on the control panel on the Rensair air purifier. Fan speed, 1(standard) to 3(highest capacity). UV-C lamp on/off indicator. The UV-C lamp will be on by default. It is recommended to keep the UV-C lamp turned on for highest air purification effectiveness.
- Page 6 The Air Quality Indicator shows the quality of air based on number of particles in the air entering the unit: The fewer bars, the better. The Rensair Air Purifier will operate continuously when in AUTO mode if the air quality is not satisfactory.
- Page 7 Re-assemble the unit in reverse order. Be careful not to damage the UV-C lamp when putting the filter back in place. After assembling, plug in the Rensair air purifier and press the RESET button, holding it down for 5 seconds. This will ensure that the Service Indicator is reset.
Need help?
Do you have a question about the Q01B and is the answer not in the manual?
Questions and answers