Set up your WorkPad PC companion
1.
Install AAA batteries as shown.
Push up on the stylus
to remove it.
2.
Configure your WorkPad PC companion.
•
Remove the protective screen film.
•
Follow the instructions onscreen to
set up your WorkPad PC companion.
Hints:
If your WorkPad PC companion does not turn on, try these steps:
•
•
•
•
•
Adjust the contrast control.
Press the power button. Your WorkPad PC companion turns off
automatically when it is not in use.
Make sure the batteries are fresh and properly installed.
Some models include a reset tip inside the stylus. Simply unscrew
the tip of the stylus, or use an unfolded paperclip, and gently press
the reset button on the back of your WorkPad PC companion.
If your WorkPad PC companion still does not turn on, hold down the
power button while pressing the reset button and then release it.