Just MPM890SD Operating And Instruction Manual

IMPORTANT NOTICE
If the supply cord is damaged, it must be replaced by the manufacturer, its service
Agent or similarly qualified persons in order to avoid a hazard.
CLEANING AND GENERAL MAINTENANCE

Before carrying out any cleaning or maintenance on the appliance,
ensure that the power supply has been disconnected.

The storage compartment, outer cabinet and all accessories of the
appliance should be cleaned with warm water and a neutral soap,

thoroughly rinsed with clean water and wiped dry. DO NOT use any

detergents or abrasive powders.

To clean the inside of the glass, the doors can be removed by firstly

unhooking the advertising panel. Move the door to the open position, then lift the
door outwards at the bottom so that it is clear of the plastic section
Now move the door to the closed position and unhook the door
by lifting it off the runner at the top. Reverse the process to replace the door.
IN THE EVENT OF NOT USING THE APPLIANCE FOR AN EXTENDED PERIOD :

Disconnect the power supply.

Remove all products from the storage compartment; clean the inner cabinet
and all accessories.

Leave the doors open in order to allow free air circulation through the inner
cabinet, thus preventing the development of bad odours and mildew.

Make sure the room is aired regularly.
WARNING
Keep ventilation openings, in the appliance enclosure or in the built in structure
Clear of obstruction.
Do not use mechanical devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
Do not use electrical appliances inside the food storage section of the appliance,
unless they are of the type recommended by the manufacturer
Do not store explosive substances such as aerosol cans with flammable propellant
in this appliance
MAXIMUM SHELF LOADING
MPM890SD 22Kg
MPM1140SDE 55Kg
MPM1360SD 55Kg
JUST REFRIGERATION
PRODUCTS
OPERATING AND
INSTRUCTION MANUAL
SLIDING DOOR MODELS