Horrothia TYPE ONE Instructions

TYPE ONE ​
All rights reserved. © Horrothia 2021.
i nstructions
DC input
The Type One must be powered by a 2.1mm, centre negative power supply, capable of delivering 100mA of
current. The unit will work at any voltage between 9 and 12 volts, but ideally you'd power it with 12 volts. At 9 volts
there is less clean headroom, or the unit distorts earlier. A good quality, linear power supply is also highly
recommended, and we don't recommend daisy chain cables. They can cause buzzes and hums.
Input jack
Input and output jacks are all high quality ¼" / 6.35mm. Plug your guitar / synth / theremin in here.
Mono / Left jack
If you are using the pedal monaurally (one amp, or into more pedals) plug the output cable in here. This will mix the
dry (unaffected) and wet (affected) signals together ensuring a shimmering chorus tone. If you are using the pedal
with two amps, plug in the amp to which you plan to feed the dry signal here.
Stereo / Right jack
This jack outputs the wet, or affected signal.
Rate LED
This LED shows the rate of the effect. When bypassed, the LED is duller, and 'winks'. When the effect is engaged,
the LED is brighter, and smoothly fades in and out.
Engage LED
When the LED is on, the pedal is engaged, and the effect is on. When the LED is off, the effect is bypassed.
Footswitch
The footswitch toggles the effect on and off as standard. You can change this by holding down the footswitch
when powering up the effect. Now the effect will only be on when the footswitch is held down. Go back to the
standard mode by removing the power, and plugging it in again.