Fisher & Paykel HBD600I Installation Manual/User Manual page 24

Downdraft unit internal blower electrical connection
Connect (L1/live) wire from the power supply
●
cable into the right terminal Fig.19.
Connect the green (ground) wire from the power
●
supply cable into the middle terminal Fig.19.
Connect the (neutral) wire from the power supply
●
cable into the left terminal Fig.19.
Ensure that the terminal screws are tightly
●
holding all wires in place.
Replace the cover of the terminal box Fig.18.
●
Fig.19
Downdraft unit remote blower electrical connection
Connect the power supply cable into the box as described in the 'Downdraft unit
●
internal blower electrical connection' section (above).
To use a remote blower, install a control cable between the downdraft unit and
●
the remote blower. See the 'Remote blower electrical connection' on next page.
Additional knock outs should be used for the remote blower wiring.
●
Install a suitable UL listed strain relief or conduit fitting (not included) into the
●
knock out.
Connect the remote blower wiring into the downdraft unit: N (neutral) into the
●
right terminal, L1 (live) into the left terminal and the green (ground) wire goes
into the ground terminal Fig.20.
Ensure that the terminal screws are tightly holding all wires in place.
●
The remote blower will be connected to the additional control cable
●
Replace the cover of the terminal box Fig.18.
●
22
INSTALLATION INSTRUCTIONS
Home power
supply cable
Internal
wiring
Downdraft wiring
Fig.18
Remote blower Home power
control cable supply cable
Fig.20
Internal
wiring
Downdraft wiring