Advertisement
Assembly instructions Classic Cabane Adirondack chair
Parts List:
• Seat assembled
• Back assembled
• Front legs
• Arms
Place the assembled Seat on its side on a flat clean surface.
Locate the Front Leg that you will be installing (Right Picture).
Insert a long connector bolt down through the outermost pre-
drilled hole in front leg and align this with the pre-drilled hole
in seat assembly. Install flat washer, lock washer, and nut.
Finger tighten nut onto bolt in Front Leg, then partially install
the other
(2) long connector bolts, washers and nuts, next to the one you
have just installed. Flip the chair over and repeat process for the
other side. Do not tighten at this time.
Hardware:
Step One: Leg Assembly
1
• (6) long Connector Bolts
• (4) short Connector Bolts
• (10) Flat Washers
• (10) Lock Washers
• (10) Nuts
• (4) Robertson head Screws
• Screw bit
Advertisement
Table of Contents
Summary of Contents for Cabane Classic Adirondack
- Page 1 Assembly instructions Classic Cabane Adirondack chair Parts List: Hardware: • Seat assembled • (6) long Connector Bolts • Back assembled • (4) short Connector Bolts • Front legs • (10) Flat Washers • Arms • (10) Lock Washers • (10) Nuts •...
- Page 2 Step Two: Arm Assembly Arms should be installed with curve side on the in- side of the chair. (Left Picture). Place Arm on top of Front Leg. Align pre-drilled hole in arm with the pre-drilled hole located at the top of the Front Leg.
Need help?
Do you have a question about the Classic Adirondack and is the answer not in the manual?
Questions and answers