Advertisement
Available languages
Available languages
Quick Links
OPERATOR'S MANUAL
To load for transportation
1. Load the fuel cart onto a trailer or truck bed and place in horizontal position. DO NOT place inside a vehicle trunk or inside the
11passenger compartment.
2. Secure the container with proper restraining devices to prevent movement in all directions. Proper restraining devices include
tie-down straps, cables or chains that are in good condition and strong enough to withstand the forces that may be
encountered during transportation. There should not be any sharp edges in contact with the plastic tank. The restraining devices
may be wrapped around the tank body in the grooved ribs or around the molded handle. DO NOT attach restraining devices to the
ball valve, hose fittings, or fill cap.
3. It is the vehicle operator's responsibility to comply with all federal, state, and local regulations for the transportation of gasoline,
and including the use of placards where required.
Storage
1. It is the user's responsibility to review and comply with all local and state building and fire codes regarding allowed quantity of
fuel that may be stored and the approved storage locations.
2. Keep out of reach of children.
3. Store in well-ventilated area.
4. Keep away from flame, pilot lights, stoves, heaters, electric motors and other sources of ignition. DO NOT store inside a residence,
living space or basement.
5. DO NOT store in an attached garage that is connected to residence or dwelling.
6. DO NOT store in vehicle passenger compartment or vehicle trunk.
7. DO NOT store in direct sunlight.
Item Description
Qty
Part No.
1
Tank - 15 Gallon
1
N/A
2
Adapter O-Ring Groove
1
14GC-05
3
O-Ring
1
9464K39
4
1/2" NPT Swivel 90° Elbow
1
1501-8-8
5
1/2" NPT M x F Ball Valve
1
BV-1/2NPTMF
6
Dispensing Hose
1
80-593-14
7
Dispensing Nozzle
1
JL-5116-1
Model: GG-15PFC
Wheels 8.0 x 2.5 Pneumatic with 5/8"
2
P825-20S-R
Bearing
8
Model: GG-25PFC
Wheels 8.0 x 2.5 Pneumatic with 5/8"
2
P1030-20S-R
Bearing
9
Flat Washer 5/8" ID Zinc Plated
4
FRWSAW062
10
Axle Caps 5/8" ID Zinc Plated
1
14174
11
Fill Cap
1
201594
7
6
4.
GG-15PFC/GG25PFC FUEL CART
1
11
3
2
4
5
9
Model: GG-15PFC/GG-25PFC
15/25 Gallon Fuel Cart
9
8
10
(UN/DOT Approved)
Operator's Manual
151 Snyder Ave.
• Barberton, OH 44203
www.ugasngo.com • customerservice@johndow.com
REV. 2/15
Advertisement
Summary of Contents for GAS & GO GG-15PFC
- Page 1 OPERATOR’S MANUAL GG-15PFC/GG25PFC FUEL CART To load for transportation 1. Load the fuel cart onto a trailer or truck bed and place in horizontal position. DO NOT place inside a vehicle trunk or inside the 11passenger compartment. 2. Secure the container with proper restraining devices to prevent movement in all directions. Proper restraining devices include tie-down straps, cables or chains that are in good condition and strong enough to withstand the forces that may be encountered during transportation.
- Page 2 Turn fill cap in direction as shown until the cap seats on tank, then turn an additional 1/4 turn. Capacity and Dimensions: GG-15PFC Capacity and Dimensions: GG-25PFC c. Turn manual vent in direction as shown until closed, then turn an additional 1/4 turn.
-
Page 3: Manuel De L'utilisateur
BV-1/2NPTMF Tuyau de distribution 80-593-14 Bec de distribution JL-5116-1 Modéle: GG-15PFC Roues 8,0 x 2,5 pneu- P825-20S-R matiques avec coussinets à bille de 5/8 po Modéle: GG-255PFC Roues 8,0 x 2,5 pneu- P1030-20S-R matiques avec coussinets à bille de 5/8 po Rondelle plate 5/8 po ID plaquée zinc... - Page 4 • Manipulez avec soin pour éviter des blessures ou la perte de contrôle. Demandez de l'aide si nécessaire, pour éviter les efforts ou les blessures. Remettez tout carburant du tuyau dans le réservoir tel qu'expliqué ci-dessus. Capacité et dimensions : GG-15PFC Capacité et dimensions : GG-15PFC 1 Fermez le réservoir a.
- Page 5 Vávula de bola 1/2” NPT M x F BV-1/2NPTMF Manguera de Distribucón 80-593-14 Boquilla de Distribución JL-5116-1 Modelo: GG-15PFC Ruedas 8.0 x 2.5 P825-20S-R Neumáticos con 5/8” Bearing Modelo: GG-25PFC Ruedas 8.0 x 2.5 P1030-20S-R Neumáticos con 5/8” Bearing Arandela Plana Galvanizadas 5/8” ID FRWSAW062 Tapas de Eje galvanizado 5/8”...
- Page 6 MANUAL DEL OPERADOR GG-15PFC/GG25PFC CARRO DE COMBUSTIBLE MANUAL DEL OPERADOR GG-15PFC/GG25PFC CARRO DE COMBUSTIBLE Instrucciones de montaje INSTRUCCIONES RELACIONADAS AL RIESGO O LESIONES A PERSONAS. 1. Envuelva ambos accesorios de la manguera con cinta de PTFE. 2. Conecte el perno de la válvula al codo de 90 ° posicionando la válvula contra el ajuste y apriete INSTRUCCIONES DE SEGURIDAD IMPORTANTES.