Fisher & Paykel RIV3365 User Manual page 80

Cooktop burners
PROBLEM
The ignitor keeps clicking
(continuous spark) even
when a burner has lit.
None of the burners will
light.
Some burners will not
light – Flames do not burn
all around the burner
cap.
There is no clicking when I
try to light a burner
There is a slight 'extinction
pop' or flash after I've
turned a burner off.
The flames have suddenly
gone out.
The burner flames are
uneven, very large, yellow
or yellow-tipped or sooty.
There is a power failure –
can I still use the cooktop
burners?
80
TROUBLESHOOTING
POSSIBLE CAUSES
Dirty or wet ignitor(s).
No power supply.
No gas supply.
Burner parts or ignitors may be
wet, dirty, or misaligned.
The ignitor is dirty or there is a
power outage
This is normal for LP gas and
requires no action.
A draft or a spill has extinguished
the flame.
Technical fault: the gas is the
wrong type or hasn't been
adjusted properly.
The cooktop burners can still
be used.
WHAT TO DO
Clean the ignitor(s).
See 'Care and cleaning'
for instructions.
Check that there is no power
outage in your area and that
the power supply to the range
is switched on at the circuit
breaker panel.
Check that the gas supply to the
house is working. You should hear
the gas when you turn a burner on.
If you are using bottled gas, check
that it is not empty.
Check that the burner parts
are clean, dry, and correctly
assembled. Ensure the ignitors
are clean and dry. See 'Care and
cleaning' for instructions.
Clean the ignitor(s).
See 'Care and cleaning'
for instructions.
No action required. The burner
will detect this and automatically
relight. However, if there has
been a large spill, we recommend
turning the burners off and
cleaning the burners and sump
area. See 'Care and cleaning' for
instructions.
Do not use your cooktop burners.
Contact your Authorized Service
Center or Customer Care.
If the flame is blown out during a
power failure, turn the dial to
as the burner will not automatically
relight and gas may escape.
,
OFF