Safety READ CAREFULLY BEFORE INSTALLING: Read this manual carefully for installation instructions. DO NOT INSTALL the dispenser where it is directly exposed to vapors, chemical fumes, or next to heat sources. PROTECT YOURSELF - Always wear personal protective equipment. Use gloves, eye ware, and appropriate attire when working with chemicals.
Mounting Instructions Step 1 Use the backplate as a template to mark the mounting hole pattern. Drill a hole for the supplied ¼” anchors and mount the bracket with the screws provided in the accessory kit. Step 2 Attach the system to the backplate and slide it down.
Page 4
Mounting Instructions Multiple Unit Installation After mounting the backplate, follow these instructions: Step 1 Slide the second bracket into the slot from top to bottom on the left side of bracket 1 until they are properly aligned and secure. Step 2 Unlock the left side of the first system by pulling the rear clip to its outward most position as shown and remove the end cap.
Troubleshooting Problem Cause Solution 1. Water inlet strainer is clogged 1. Clean it or replace if necessary 2. Use a water pressure regulator in case of 2. Too much water pressure more than 100PSI 3. Insufficient water pressure 3. 20PSI is the minimum required pressure. System does not dispense solution 4.