Advertisement
STEP 1
Insert (20) Part "A"
into holes as shown.
IMPORTANT!!!
NOTE ORIENTATION OF
PART "A". OPEN (HOLE)
SECTION MUST FACE
TOWARDS THE
F
V
CORRESPONDING HOLE
RONT
IEW
IN EDGE OF PARTS #4 & #5.
"A"
OF
(ALL 20 PLACES)
THE ARROW ON TOP OF
PART "A" WILL ALSO
POINT TOWARDS THE
CORRESPONDING HOLE
IN EDGE OF PARTS #4 & #5.
T
V
OP
IEW
"A"
OF
STEP 2
Connect Parts #4 & #5 to
BOTTOM PART #1 FIRST.
Using a screwdriver, turn Part
"A" clockwise to lock onto Part
"B" on BOTTOM Part #1.
Repeat with TOP PART #2.
STEP 3
Attach hardware to
BOTTOM of door FIRST.
C
D
Inside of
Door
3
F
2X
STEP 4
F F O O L L L L O O W W S S T T E E P P S S I I N N O O R R D D E E R R : :
1. PLACE ONE SPACER "E" INTO THE HINGE
HOLE IN BOTTOM OF PART #1. NOW PLACE
THE BOTTOM DOOR HINGE INTO THIS SPACER.
2. PLACE ONE SPACER "E" ONTO THE TOP
DOOR HINGE AND INSERT IN THE HINGE HOLE
ON TOP PART #2. SECURE TOP HINGE "G" TO
DOOR WITH (2) SCREWS "F" AS SHOWN.
IMPORTANT
IF DOOR DOES NOT OPEN PROPERLY OR IF PART
"G" MOVES WHILE OPENING DOOR, CAREFULLY
RE-CHECK THE INSTALLATION OF PART "G".
A COMMON MISTAKE IS TO INSTALL PART "G"
BACKWARDS. PLEASE REFER TO PICTURES
IN STEPS 3 & 4 FOR CORRECT ORIENTATION.
This aquarium stand is under warranty by Marco Group, Inc. against defects in material and workmanship for 90 days from the date of purchase. If any
component of the stand is found to be defective, you may contact us for replacement provided it has not been modified, damaged or misused.
THIS WARRANTY IS VOID if the aquarium stand is modified, if it is not placed on a flat, level surface, if it is used with a tank other than it is designed, if it is
This warranty is limited to replacement of the stand only. Warranty does not cover loss of fish, personal injury, property loss or damage arising out of use of the
aquarium stand. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you. This warranty gives you specific legal rights and you may have other rights that vary from state to state.
A
B
Screw (20)
Part "B"
into holes
as shown.
This side
faces to
INSIDE of
NOTE:
Lock bottom
assembly FIRST.
G
E
HINGE
HOLE
(Proof of date of purchase must be provided).
moved with the tank in place or if it is used for other than it's intended purpose.
4
4
1
stand
5
4
E
F
2X
G
Outside
of Door
BOTTOM
DOOR
HINGE
LIMITED WARRANTY
5400 DONIPHAN DRIVE
NEOSHO, MO 64850
4
NOTE! HOLES & PART "B"
SHOWN HERE ARE ON
UNDERSIDE OF PART #2
2
4
This
side
faces to
INSIDE
of stand
NOT
USED
NOT
USED
1
STEP 5
H
D
5
5
2
This side
faces to
INSIDE of
stand
5
4
IMPORTANT
NOTE!
Y
MUST
OU
P
T
OSITION
ANK
T
OWARDS THE
B
S
ACK
IDE
S
.
OF
TAND
85155
Pg. 2
Advertisement
