Advertisement
Micro-Glow V-6-R2
WARNING!
IF YOU HAVE A FLOODED/FUELED ENGINE SIMPLY TURNING ON YOUR GLOW CAN
START YOUR ENGINE!
Never Touch the Prop or be IN FRONT of a prop with glow "Active"
NEVER TURN OR FLIP WITH YOUR-HANDS-EVER FOR ANY REASON!
Consider the fact that the engine can begin to run at "ANY TIME" without being touched once glow is
active!
YOU AND YOU ALONE Are Responsible for your own safety.
*************************************************************************************
If your Glow system includes a battery it must be charged with a charger rated to charge a single cell
1.2V and Ni-Mh type.
Charge Rate can be as little as 1.0 Amps (3.8 hours charge) or as high as 3.8 Amps(1 hour charge)
*Triton*Astro* and many others are perfect for charging the included battery if RTF.
NEVER let your Ni-Mh cell go to 0 volts or dead, permanent damage will result.
After about 1 to 1.5 hours of flying check and recharge your battery.
If you did NOT buy a RTF system then you need a cell rated for R/C use of at least 3000 ma to 4200 ma.
Alkaline types are never to be used! They are not rated for R/C loads and can explode/leak in your plane!
So called Radio Shack or other super market rechargeable cells are also not to be used.
Again they are not rated for R/C loads and can leak or explode in your plane.
Install high current type connectors such as DEAN's / Power Poles
Never use simple bullet type wire crimps or other twist type connecters. Always use a solder type of
connecter and heat shrink the connections.
If you must make the Glow leads longer use only 18 Ga or larger wire and never longer than 36" or use
more than 5 glows at up to 36" ea using 16ga wire Ea.
Solder and heat shrink all new connections and grounds there must be at least 1 ground Per Engine.
It is not needed to ground ea plug in multi plug engines, 1 at ea engine block mounting is fine.
If you would like a battery system you can purchase (1) from us or your dealer that includes all you need
to get going [3000-3800ma cell with deans plugs and chg jack all soldered and ready to install]
42% Products USA
Ken Anderson
916-821-2635
42-Perecnt-Products
sales@42-percent-Products.com
Advertisement
