Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for WETJET WJ85.403.014
Summary of Contents for WETJET WJ85.403.014
- Page 1 14" Surface Cleaner WJ85.403.014 User Manual 85.610.706...
-
Page 3: Table Of Contents
TABLE OF CONTENTS Introduction Using the Operator’s Manual Product Identification Record Identification Numbers Pre-Operating Instructions Before You Begin Intended Use Care Operating Operating Recommended Applications Use with a Gun and Lance Parts List Troubleshooting & Parts List Warranty Warranty... -
Page 4: Introduction
INTRODUCTION Attention: Read through the complete manual prior to the initial use of your Surface Cleaner. Using the Operator’s manual The operating manual is an important part of your 14" Surface Cleaner and should be read thoroughly before initial use, and referred to often to make sure adequate safety and service concerns are being addressed. -
Page 5: Product Identification
PRODUCT IDENTIFICATION Record Identification Numbers 14" Surface Cleaner If you need to contact an Authorized Dealer or Customer Service line (1-866-850-6662) for information on servicing, always provide the product model and identification numbers. You will need to locate the model and serial number for the pump and record the information in the places provided below. -
Page 6: Pre-Operating Instructions
PRE-OPERATING INSTRUCTIONS Pre-Operating Instructions Before You Begin Prior to initial operation of the unit carefully read the information outlined in the operation instructions. • Ensure that all components are in good working order and that they operate safely. • Do not use cleaner if any part is not in proper working condition. •... -
Page 7: Operating
OPERATING Operating Never reach under the unit while the high-pressure cleaner is operating • Never direct the 14" Surface Cleaner at humans or animals. • Do not operate on a ladder. WARNING Nozzle has been set according to factory set alignment. During operation, should you experience a buildup of small stones or other foreign material within the cover, we recommend that you simply tip the cleaner on its side at 45°... -
Page 8: Parts List
TROUBLESHOOTING / PARTS LIST Troubleshooting Problem Cause Solution • 1 or more plugged nozzles • Clean or replace nozzles Rotary arm not • Nozzles not aligned with arm • Realign nozzles spinning • Damaged nozzle or rotary arm • Replace damaged part(s) Leaking water from •... -
Page 9: Warranty
WARRANTY Warranty This surface cleaning unit has a three months limited warranty on all components except for the nylon brush ring. This includes the rotary head, the nylon brush ring, and plastic cover. This warranty covers manufacturer defects only and does not extend to any damage caused by the user. - Page 10 If you need assistance with the assembly or operation of your Surface Cleaner please call 1-866-850-6662...