Advertisement
Quick Links
Items Include:
• Main Motor
• Metal Floss Bowl
• Mesh Stabilizer with clips (5)
• Pink bubble cover
Electrical Requirements:
This candy floss machine is ready to plug into a 15 amp., 120 volt/60 cycle standard wall
receptacle. The power supply cord is equipped with a machine ground. For safety, always
plug the machine into a grounded receptacle.
Operating Instructions:
1. Place machine in a well ventilated area on a sturdy table or surface with the controls facing
the operator. Unscrew the two transport screws on the unit on either side of the floss head.
DO NOT run the machine with these screws in the "up" position.
2. Lower shipping saddle by turning the two knobs on each side of the bell
housing, then push them down to assure that the saddle is completely lowered.
3. Place the Floss bowl on the motor assembly. It rests on the rubber stoppers on the motor
assembly- it does not connect or hook to the machine in any way.
KNOB
KNOB
4. Place the mesh stabilizer around the inside edges of the bowl, overlapping the points around
the bowl. Slide the metal clips (5) over the bowl and the mesh at several areas around the
bowl.
5. Place the bubble dome on top of the floss bowl, pointing the opening on the same side as
the machine controls. This is where the operator will stand.
Knob
6. Without the motor running...fill floss head about 90% full with the sugar.
Knob
DO NOT OVER FILL AND NEVER ADD SUGAR WHEN MOTOR IS RUNNING.
After adding sugar, manually rotate head to balance.
7. Turn on both heat and motor switches, then turn the heat on high until you start to see the
floss forming. Then turn the heat back to a medium setting. After warm up, equipment should
make good floss at a reduced setting. Never let the machine operate with the heat so high it
produces smoke or causes the sugar to burn.
8. Once an ideal setting is found for the HEAT CONTROL, you should be able to operate near
this position each time.
9. See attached on making floss before going into full production.
ECONO
COTTON CANDY
MACHINE
Advertisement
Summary of Contents for PETE'S ECONO
- Page 1 ECONO COTTON CANDY MACHINE Items Include: • Main Motor • Metal Floss Bowl • Mesh Stabilizer with clips (5) • Pink bubble cover Electrical Requirements: This candy floss machine is ready to plug into a 15 amp., 120 volt/60 cycle standard wall receptacle.
- Page 2 Making Floss Pick a cone; if it sticks in the stack of cones, twist it off the stack. Hold an inch or two of the pointed end of the cone between two fingers and a thumb. With a light flicking action, roll cone in the web of floss building up in the pan. Lift the cone up with the ring of floss attached and rotate the cone to wrap the floss.