Page 1
SKU NO. : FP-4TSO-596G Model : JPD101 Patent No. : US 8,381,661 B2 FLIP FRAME WALL CABINET Operator’s Manual p. 5 Customer Service : 1-866-216-1072 Our Customer service staff is available to help you. For help with product assembly, to report damaged or missing parts, or for any other information about this product, please call our toll-free number.
2. Do not load the unit with more than 5 pounds per shelf. 3. Do not load the unit with more than 20 pounds for the whole cabinet. 4. Close supervision is necessary for Flip Frame if being used near children. 5. Safely discard all packing material.
Page 3
PREPARATION Please make sure all parts are available before beginning to install the product. Compare parts with package content list and hardware content list. If any part is missing or damaged, do not attempt to assemble, install or operate the product. Contact customer service for replacement parts. Estimated assembly time: 20 minutes Tools required for assembly (not included): Phillips screwdriver, electric drill, hammer, carpenter’s level.
Page 4
ASSEMBLY INSTRUCTIONS 3. Insert screws (D) through the predrilled holes inside the French cleat (F) and into the anchors (E) and tighten securely. 4. Hang the cabinet (A) onto the French cleat (F). 5. Mark the wall through the predrilled hole in cabinet (A) with a pencil.
Page 5
REMINDER If you wish, replace the photos with your favorite ones. Please be careful and follow the instruction below See instructional video at www MyFlipFrame 1. Change picture while the unit is secured to the wall. Take the batten (G) out of the back of front frame. 2.
4. Put the batten (G) back. CARE AND MAINTENANCE Glass: Wash and clean regularly using a non-abrasive neutral (pH balanced) glass cleaner. Light scratches can be taken out by using a mild abrasive product. Rinse surface thoroughly afterward. All spills should be cleaned immediately. Do not allow acidic substances, such as vinegar, to rest on the glass surface as it will permanently cause a cloudy appearance.