Moebius ParaGrafix PGX128 Quick Start Manual

The Moon Bus
Thruster &
Rocket Set
Add screen accurate rocket nozzles
and the missing RCS thrusters to the
Moebius Models Moon Bus kit.
Includes resin parts and brass rod.
Works great with ParaGrafix photoetch
set PGX127.
"Moebius"® is a registered trademark of Moebius Models.
ParaGrafix™ is a trademark of Paul H. Bodensiek dba ParaGrafix.
Copyright © 2010 Paul H. Bodensiek. All rights reserved.

Rocket Nozzles

Cut and bend the brass rod as shown (30 pieces are needed - 5 for each nozzle). A
bending gig is provided.
Glue the brass into rocket nozzles - you may want to enlarge the mounting holes
slightly as they were made small to mold properly.
Attach the rocket nozzles to the gimbals and them glue them in place in the
existing kit holes. Note that the nozzles should point straight out the sides to
provide the accurate dihedral angle.
Key Key
Kit part (plastic):
Resin part:
PGMS
ParaGrafix ParaGrafix
Modeling Systems Modeling Systems
www.paragrafix.biz
P/N: PGX128
For
Kit 2001-1
and classic Aurora kit
1
A
The Moon Bus
Thruster &
Rocket Set
PGMS
ParaGrafix
Modeling Systems
www.paragrafix.biz
P/N: PGX128
0.08" (2mm)
x5 / engine