This mode is mostly recommended to be used for recording and analyzing the signal in a PC in combination with a frontend. Amplification Differently to the Microflown signal conditioner, the S&L device is a simplified version, allowing High gain operation. NOTE: If Low gain amplification is needed, then a signal conditioner should be used.
Page 4
The system works as a simplified equalizer for the Listening function, leaving the signal intact for the signal out function (non-corrected mode). Listening functionality The equalization module implemented in the S&L device is simplified compared to the Microflown signal conditioner electronics. The equalization performed enhances high frequencies applying fc2 filter.
To operate the system in battery mode, insert the battery block on the side of the device. Microflown technologies, Tivolilaan 205 6824 BV, Arnhem. The Netherlands W: www.microflown.com E: info@microflown.com T: +31 88 001 0811 F: +31 88 001 0810...
Page 9
When the power connector is used and the power switch turned on, the P-U switch with led, should be lighted. Microflown technologies, Tivolilaan 205 6824 BV, Arnhem. The Netherlands W: www.microflown.com E: info@microflown.com T: +31 88 001 0811 F: +31 88 001 0810...
Use parts, connector and power supplies provided with the equipment. Do not use the device with any cable or extension cable not supplied by Microflown Technologies. In case of losing some part please consult with Microflown Technologies before using a similar item.
Repairs come with six months’ warranty with the same condition as the two year warranty Microflown technologies, Tivolilaan 205 6824 BV, Arnhem. The Netherlands W: www.microflown.com E: info@microflown.com T: +31 88 001 0811 F: +31 88 001 0810...
Need help?
Do you have a question about the Scan & Listen and is the answer not in the manual?
Questions and answers