Dongguan Yuehui Electronic Technology VS-808 Quick Start Manual

GAMEPAD VS-808

Features

：
1) This handle is compatible with the Switch host.
2) No need to load any driver, the handle can be used after connecting with the Switch host.
3) Wireless Bluetooth connection, strong anti-interference ability, stable connection signal, and easy control.
4) Built-in lithium battery.
5) This handle supports the gyroscope axis function and the dual motor dual vibration function.
6) Up to 4 pairs of wireless controllers can be connected to the host at the same time.
7) The game can also be played normally when the handle is charged.
8) This handle can be upgraded with updated software by connecting to a computer.

Key introduction:

① Left handle
1) MODE key*1: command to turn on the handle or pair with the host, long press to pair, short press to shut down
2) Arrow keys*1 group: up, down, left, right
3) 3 function buttons: -, LB, LT, SL, SR, L3
4) Screenshot key*1: Click this key in the game to take a screenshot and save the current screen
5) Left joystick*1: 3D joystick
6) Reset button *1: Press this button to turn off the power of the handle, and disconnect the handle from the host
② Right handle:
1) MODE key*1: command to turn on the handle or pair with the host, long press to pair, short press to shut down
2) Function keys *4: A, B, X, Y, RB, RT, +, SR, SL, R3
3) HOM key*1: return to the main interface
4) Right joystick*1: 3D joystick.
5) Reset button *1: press this button to turn off the power of the handle, and disconnect the handle from the host

Connect the handle through the Switch host track:

① Use the left and right handles to insert into the left and right rails of the Switch host from top to bottom in the correct
direction. After the connection is successful, the matching success will pop up in the upper left corner; after the second time
the connection is successful, a blue bar will pop up on the left of the Switch host, and the right will pop up Red bar
② Pull out the left and right handles, you need to press the buckle buttons at the bottom of the handle to pull out smoothly;
after pulling out the handle, the handle will automatically pair with the Switch host; there will be two small white handle
icons in the lower left corner after the connection is successful

Connect to the Switch host via Bluetooth:

① When the handle is not connected through the Switch host track, the first time the handle is connected to the host:
Turn on the Switch host, in the host's main menu interface, touch and click Controllers → Change Grip/order with your
finger to enter the host pairing mode interface Press L + R on the controller; on the handle, long press the MODE button and
the handle indicator light is fast Flashing enters the pairing mode. When single or multiple LEDs are always on, the handle is
successfully paired with the host; if it is a single handle, press and hold SL+SR at the same time to enter the use state, if it is
Rev 1.0
BM-827S Bluetooth SWITCH Handle Function Description