Installation of KoolSource KS-1 Lines Connections: Out: From Pump to Coffee IN located in the back In: from RTD product IMPORTANT: Your RTD product most be connected to the pump before the system is being turn “ON” Power Requirement for Machine:...
Page 4
Dispensing taps and accessories 1. NITRO/ICED & COLD BREW COFFEE Single dispensing tap 2. NITRO dispensing tap – stainless steel disc must be mount between tap and shank 3. Two beverages can be dispensed from the same tap by swithching on and off the nitro activator 4.
Connection Schematic Picture 5 : Connection schematic – one type of product 1. Nitrogen Flow Regulator 2. Nitrogen Pressure regulator 3. Cleanout System 4. Nitro Pump Switch 5. Coffee Inlet 3/8’’ Quick-connect 6. Main Pump Switch #INNOVATIONS 4U! info@absystems.ca (855)532-5522...
Page 6
Nitrogen and Product Flow adjustment The product flow adjustment is very important for the quality of your drinks Important: Dispensing valve (D) must be Horizontal for Dispensing the product before starting A) Nitrogen Flow adjustment: a. Make sure the the valve is completely close at the 0 position b.
Daily Cleaning Instructions ➢ Daily ✓ Is very important is to keep your KoolSource System clean, the surface, around, dispensing towers, taps and drip trays. ✓ The regular maintenance planning (cleaning) is necessary to extend the life of your system. ✓...
Weekly Cleaning Instructions ➢ Weekly Clean your KoolSource system by following all instruction carefully • USE COLD WATER FOR THE CLEANING PROCESS • Prepair cleaning products fron your 1-2 Cold Brew Kit • Diluded 30ml of Clearly Cold Step 1 on 4 liters of cold water.
Monthly Cleaning Instructions ➢ Every month The cleaning your KoolSource System is extremely important to prolong the performance and life of the equipment. • Start by following the routine of you Daily & Weekly Cleaning Instructions • Clean inlet condenser coil located on top of the unit with vacuum cleaner or brush if necessany.
Page 10
Troubleshooting Instructions PROBLEM CAUSE SOLUTION • Reset pump by turn it off for 2 minutes • Air-lock • Clean Filter Strainer (Monthly Cleaning instructions) • Pump runs but doesn’t Air leakage • Verify all your lines from the RTD to the unit for leakage •...