Advertisement
Quick Links
OptoLink Handling instructions
Follow these instructions carefully to ensure correct use of your
OptoLink connector and penetrator harnesses.
Assembly
OptoLink A-CCP to OptoLink A-FCR, BCR or CCR receptacle
Step 1:
Inspect the connector face and O-rings
Grease the O-rings with Molykote 111
Step 2:
Inspect the connector surface. If the connector surface is
dirty, follow the OptoLink maintenance instructions overleaf
Step 3:
Visually align the key way on the CCP connector with the
key pin tip on the receptacle before mating (illustration A)
Do not twist the connector to align it during mating
Step 4:
Push to mate the connector (illustration B)
Step 5:
Whilst turning the locking sleeve (illustration C)
Note: The connector must be hand tightened
B
C
A
Advertisement
Related Manuals for MacArtney OptoLink A-CCP
Summary of Contents for MacArtney OptoLink A-CCP
- Page 1 OptoLink Handling instructions Follow these instructions carefully to ensure correct use of your OptoLink connector and penetrator harnesses. Assembly OptoLink A-CCP to OptoLink A-FCR, BCR or CCR receptacle Step 1: Inspect the connector face and O-rings Grease the O-rings with Molykote 111 Step 2: Inspect the connector surface.
- Page 2 Maintenance OptoLink A-CCP, A-FCR, BCR or CCR receptacle ■ If the optical lenses are dirty, clean with a dry cotton swab and isopropyl alcohol ■ If the optical lenses are greasy, clean with an isopropyl alcohol soaked cotton swab followed by a dry cotton swab ■...
- Page 3 Stainless steel, titanium 41.0 7/8’’ - 14 UNF Brass, aluminium 60.0 Stainless steel, titanium 80.0 Recommended oil for pressure balanced systems FCR and BCR rated to 600 bar back pressure ■ MacArtney recommend DC-200/350 or PMX-200/350 in oil compensated systems...
- Page 4 For further support and advice, please contact your local OptoLink distributor or MacArtney (www.macartney.com)